Chauvet Projector Accessories user manual Master/Slave Mode Sound-Active, Standalone, Automatic

Page 10

Master/Slave Mode (Sound-Active)

This mode allows a single unit, the master, to operate in either automatic or sound-active mode. When additional (slave) fixtures are daisy chained to the master, they will all synchronize with the master and run the same lighting show.

Please see the instructions below for details on this mode.

Master:

1.Place the master fixture first in the daisy chain.

2.Set the master fixture to operate in either automatic or sound-active mode; please see the appropriate sections of this manual for details on this procedure.

Slave:

1.Daisy chain from the output of the master fixture.

2.Press <MODE> until SLAU appears on the LED screen.

Plug the master fixture in LAST!

Only connect 31 slave fixtures when operating in this mode!

Using the “Invert” function will invert any fixture(s) it is active on. This is useful when you desire to have symmetry to your lighting show. Please see the “Menu Map” for further details.

Standalone

Sound-Active

Please see the instructions below for details on this mode.

1.Plug the fixture into power.

2.Press <MODE> until SoUd appears on the LED screen.

3.Press <ENTER>.

4.Use the microphone sensitivity adjustment knob to adjust the fixture to react to the beat of the music.

5.Press <ENTER>.

The microphone will only respond to low frequencies (bass).

Automatic

Please see the instructions below for details on this mode.

1.Plug the fixture into power.

2.Press <MODE> until AUTO appears on the LED screen.

3.Press <ENTER>.

4.Using <UP>&<DOWN>, adjust the program speed (S_ _1~S100) (fast~slow).

5.Press <ENTER>.

4. Operating Instructions

10

1/13/2011 5:38 PM

Image 10
Contents Page Table of Contents Unpacking Instructions What is includedBefore YOU Begin Manual ConventionsSafety Instructions Introduction Product OverviewAC Power SetupPower Linking Mounting Operating Instructions Using the Control PanelConfiguring the Starting Address Menu MapDMX Operation OperationDMX Channel Values Sound-Active Master/Slave Mode Sound-ActiveStandalone AutomaticGeneral Troubleshooting AppendixData Cabling DMX PrimerFixture Linking Daisy Chain DMX Data CableInput Cable ConnectorsSetting the Starting Address OutputPin to 5-Pin Conversion Chart Setting up a DMX Daisy ChainReturns Procedure General MaintenanceClaims Technical Specifications World Headquarters Contact USUnited Kingdom & Ireland