Mounting
Orientation
The 6SPOT™ may be mounted in any position, provided there is adequate room for ventilation.
Rigging
This fixture has multiple rigging options. They are as follows:
Floor Standing (using the two mounting/standing brackets)
Hanging (using the two mounting/standing brackets)
Hanging (using the two hanging clamp Mounting points)
Be sure that the structure can support the weight of the fixture. Please see the “Technical Specifications” section of this manual for a detailed weight listing. Mount the fixture securely. This may be done with a screw, nut and bolt, or a mounting clamp.
The hole in each bracket is 13 mm in diameter.
When rigging, consider routine maintenance and control panel access. Please see the following notes on installation.
•If the power link out is intended to be used with multiple fixtures, take into account the length of each power cable, and mount the fixtures close enough to one another to accommodate for this.
•When aiming the fixtures, use the bracket/yoke adjustment knobs. Loosen the knobs, adjust to the desired angle, and then tighten the knobs by turning them clockwise. Do not use tools for this step, as it may cause damage.
•Safety cables must always be used!
Pod Adjustment Knob
Fixture Adjustment
Knob (2)
Hanging Clamp
Mounting Point (2)
Mounting/Standing
Bracket (2)
3. Setup | 7 | 1/13/2011 5:38 PM |