Chauvet Projector Accessories user manual Safety Instructions

Page 4

Safety Instructions

Please read these instructions carefully. It includes important information about the installation, usage and maintenance of this product.

Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.

Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture.

This product is intended for indoor use only!To prevent risk of fire or shock, do not expose fixture to rain or moisture.

Make sure there are no flammable materials close to the unit while operating.

The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

Always disconnect from power source before servicing or replacing fuse and be sure to replace with same fuse source.

Secure fixture to fastening device using a safety chain.

Maximum ambient temperature (Ta) is 104°F (40°C). Do not operate fixture at temperatures higher than this.

In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center.

Never connect the device to a dimmer pack.

Make sure the power cord is never crimped or damaged.

Never disconnect the power cord by pulling or tugging on the cord.

Never carry the fixture directly from the cord. Always use the hanging/mounting bracket.

Avoid direct eye exposure to the light source while it is on.

1. Before You Begin

4

1/13/2011 5:38 PM

Image 4
Contents Page Table of Contents What is included Before YOU BeginUnpacking Instructions Manual ConventionsSafety Instructions Introduction Product OverviewAC Power SetupPower Linking Mounting Using the Control Panel Configuring the Starting AddressOperating Instructions Menu MapDMX Operation OperationDMX Channel Values Master/Slave Mode Sound-Active StandaloneSound-Active AutomaticGeneral Troubleshooting AppendixDMX Primer Fixture Linking Daisy ChainData Cabling DMX Data CableCable Connectors Setting the Starting AddressInput OutputPin to 5-Pin Conversion Chart Setting up a DMX Daisy ChainReturns Procedure General MaintenanceClaims Technical Specifications World Headquarters Contact USUnited Kingdom & Ireland