GE 450, IC752CTD400 manual Mounting Procedure, Panel Cutout Dimensions

Mounting Procedure

1. Cut out the panel to the dimensions shown. The cut-out dimensions of 367 x 255mm

(14.45 x 10.04 inches) allow a 1.5mm (0.06 inch) clearance on each edge of the Touch Display unit.

Figure 2. Panel Cutout Dimensions

2. Position the Touch Display unit in the cut-out and fit the ten spring-loaded retaining clips into the slots. All ten clips must be installed to achieve a good seal.

Figure 3. Mounting the Touch Display Unit

3. Screw in the tightening screw on each clip so that the nut compresses the spring. To ensure a good seal between the Touch Display unit and the panel, tighten the clips evenly (tighten each of the ten clips in turn, a little at a time).

4. Stop tightening the clips when the springs are fully compressed — at this point the Touch Display unit is locked in place.

6 CIMPLICITY® Display Station Touch Display: IC752CTD400/450 – March 1998 GFK-1425B