GE IC752CTD400, 450 manual Installing ISA-Compatible Cards, Card Clamp

Installing ISA-Compatible Cards

The Touch Display rear panel must be removed in order to gain access to the ISA bus cards. There are six screws securing the rear panel. When these are removed, the rear panel can be lifted away from the main unit.

Warning

Switch off the unit and disconnect the main power input before removing the rear panel.

Blanking Plates

Blanking plates are installed on each unused card position. Remove blanking plates as necessary to install new cards. Empty slots must always have a blanking plate installed, otherwise the air flow through the unit will be affected.

Card Clamp

A card clamp bracket, which can accommodate the two standard heights of ISA bus cards, is fixed inside the rear panel. The card clamp bracket has nylon card-securing blocks fitted above each vacant card position. When installing a full height card in one of these positions, remove the long block from the appropriate position on the bracket and replace with a short block.

Full height cards — 114mm (4.5 inches) approx. — are secured by short nylon blocks

Low height cards — 100mm (3.9 inches) approx. — are secured by long nylon blocks

Figure 4. Card Clamp

GFK-1425B Touch Display Products: IC752CTD400/450 7