Troubleshooting
Powerup
Symptom | Possible Causes | Solution |
|
|
|
For Windows NT systems only: | You did not type ge for the | Set the logon password to ge. For |
The following error message | password during initial setup. | instructions, see “Auto Logon |
appears: |
| Error Message” on page 33. |
The system could not |
|
|
log you on. Make sure |
|
|
your User name and |
|
|
Domain are correct ... |
|
|
|
|
|
Display Station does not power | Power not on (PWR indicator not | Make sure that Display Station is |
up. | lighted or display completely | plugged in. Make sure that power |
| dark). | source is functioning properly. |
|
|
|
Display is blank (PWR indicator is | See “Display” on page 28. | See “Display” on page 28. |
lighted). |
|
|
|
|
|
Disk in floppy disk drive. | Remove floppy disk and then | |
error message displayed. |
| reboot or power cycle. |
|
|
|
Safe Recovery Error | Occurs on initial power up if the | The Display Station will power up |
message displayed. | unit is accidentally turned off | normally. |
| without first shutting down the |
|
| Windows 95 software. |
|
|
|
|
Memory count during powerup | Optional SIMM is installed | Make sure that the appropriate |
incorrectly or is incompatible with | memory is installed correctly. | |
| the Display Station CPU. |
|
|
|
|
CMOS checksum error — | CMOS battery failure. | Note: This battery has a lifetime |
Defaults loaded |
| of up to 10 years under normal |
CMOS battery failed |
| operating conditions. The battery |
message displayed. |
| is not field replaceable. For more |
| information, see “CMOS | |
|
| |
|
| Checksum Error” on page 33. |
|
|
|
A screen appears just after | The DEL key has been | Cycle power again. The Display |
powerup, or just after reset, which | accidentally pressed. | Station will power up normally. |
has the title “CMOS Setup |
|
|
Utility.” |
|
|
|
|
|
The Display Station reset even | The | This should never be done, unless |
though the power was not | pressed twice at the same time. | you are attempting to reset the |
interrupted. |
| Display Station. |
|
|
|
A:> appears instead of software. | A system floppy disk is inserted. | Remove disk and cycle power. |
|
|
|
| Touch Display Products: IC752CTD400/450 | 27 |