Installing the Floppy Disk Drive
The floppy disk drive is designed for mounting on the rear panel of the Touch Display unit. Two locating slots in the rear panel accept the two metal brackets on the disk drive housing. A thumbscrew fastens the drive assembly to the rear panel. A ribbon cable, terminated with a
Figure 6. Floppy Disk Drive Mounting
Caution
The Touch Display unit must be powered off before the disk drive connector is connected or disconnected. Failure to observe this precaution will result in damage to the equipment.
Install the 3.5 inch disk drive as follows:
1. Power down the Touch Display unit.
2. Fit the disk drive brackets into the two locating slots on the Touch Display rear panel (refer to Figure 6).
3. For temporary attachment, tighten the fastening screw finger tight. For permanent attachment, use a screwdriver to tighten the screw.
4. Connect the
5. Power up the Touch Display unit and check that there are no boot up error messages relating to the floppy disk drive.
6. To test the drive, insert a formatted disk and select 3 ½ Floppy (A): in Windows Explorer or File Manager.
10 | CIMPLICITY® Display Station Touch Display: IC752CTD400/450 – March 1998 |