System Setup
Figure 7
Example 2: Wave/PC™ system connections
Audio plug
Serial data port
Serial data port (DB9) connector
Rear panel of computer |
|
Audio | DIN socket |
output |
|
jack |
|
DIN connector
Wave/PC system cable
Connecting the power cord to the Wave/PC unit
1.Plug the small end of the power cord into the power jack on the back of your Wave/PC unit (Figure 8). The connector is shaped to fit in only one direction. Line up the flat edge of the plug with the flat edge on the side of the jack.
2.Connect the other end of the power cord to an AC (mains) outlet. The clock time display should begin flashing. The flashing will stop during software installation when the clock is set by your computer.
Figure 8
Connecting the power cord
PDF259774_00 | April 12, 2001 | 11 |