Brother PT2730VP manual Adjusting the Label Length, Prints a strip of labels with no cuts Between

	• Prints a strip of labels with no cuts in
	between.	ABC ABC
No Cut	• Pressing the Preview while holding down
		0.94"	0.31"
	Shift key will feed and cut the last label
	printed.	(24 mm)	(8 mm)
	• Select this setting when using special tape.
Special	• When using Fabric Iron-On Tapes or Extra	ABC ABC
	Strength Adhesive Tapes, set "On" for
		0.94"
Tape	Manual Cutting before printing. After
	printing, remove the tape cassette from the	(24 mm)
	machine and use scissors to cut the tape.

• When using Fabric Iron-On Tapes or Extra Strength Adhesive Tapes, refer to the above "Special Tape".

•The tape is not cut after the last label is printed when “Chain” or “No Cut” is set. Hold down the Shift key and press the Preview key to feed and cut tape automatically, or cut the tape manually if you are using Fabric Iron-on Tapes or Extra Strength Adhesive Tapes.

Adjusting the Label Length

You can adjust the length of the printed label in levels of -5 to +5.

1Press the Setup key to display the setup menu, select "Adjust Length" using the

or key, and then press the OK or Enter key.

2Select "Adjust Length" by using the or key, and then set the value by using the or key.

3Press the OK or Enter key to apply the setting.

• Press the Escape key to return to the previous step.

• Press the Space key to set the value to default setting.

• Approximately 1% of the total label length will be adjusted by 1 level.

z LABEL PRINTING

1

2

3

4

5

6

7

8

9

Adjusting the Label Length

58