Unit IP Settings

Enter a 1 to configure the IP addresses of the FaxReceiver ModuLAN 200.

Your Network Administrator should provide the Unit IP and Unit Gateway address.

1)Unit IP address .......... 011.022.033.044 – should be changed to an unused IP address on your network.

NOTE: If you use static IP addressing, and you have a DHCP server, this IP address should be added to your DHCP Server’s static IP address list.

NOTE: If you enter an invalid IP address format, you will get a “>>>>>> Not a valid IP address Format” message.

2)Subnet Mask – Enter the subnet mask used for your network.

3)DNS Address 1 – Enter the primary DNS Server’s IP address provided by your ISP for your network.

4)DNS Address 2 - Enter the secondary DNS Server’s IP address provided by your ISP for your network.

5)Gateway Address ............... 011.022.033.001– should be changed to the IP address of your default gateway. Typically, this is the lowest address on the subnet, for example 192168100.001.

6)DHCP/RARP – This is a toggle. Entering 3 will switch from Disabled to Enabled and back.

NOTE: If you change to an address that is NOT in the same network range that your PC is, you will still be able to see the FaxReceiver with the FaxConfig utility, but you will not be able to change any parameters until you are on the same subnet. If you use DHCP or RARP you must figure out what IP address it obtained. Methods for doing this are covered in the troubleshooting section.

Page 23 of 49