5, 6, 7) Timeserver 1 address....192.043.244.018 – The 192.043.244.018
address is the time server at NCAR. You can change this to a preferred timeserver and add two more timeservers. Without a timeserver the timestamp will be incorrect and your spam filter may trap the email.
NOTE: All timeservers send the time UT. In order to set the time stamps correctly you must adjust your Time Zone Offset in the Setup Fax section.
There is a list of public timeservers at this URL:
R)Press R when the Unit IP settings are all configured to return to the top menu.
NOTE: Unlike all of the other setup parameters, IP addresses do not take effect immediately, because a change to those would cut off the telnet session. You can use the “Reboot after quitting” to enable the IP addresses without disconnecting power.
To enable IP Addresses:
1)Save each setting.
2)In the initial menu, set “Reboot after quitting” to Enabled.
3)Use Q to quit and select Y to the question: “Do you want to save your changes before quitting (Y/N)”.
Copyright 2006 Ringdale User Manual, | Page 24 of 49 |