Tiger 70709 manual FCC Statement

Page 30

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio TV technician for help.

57

58

Image 30
Contents Item No Introduction Contents Configuration of the Wonderborg How to Make the WonderBorg Work WonderBorgs Intelligence ProgramTools Required Hardware BasicsNames of Parts List of PartsBasics Set of Rubber Parts with runnersOther Parts Installing the Motherboard Fitting the LegsFitting the Antennae Extra Information AAA/LR03Hardware Variations Changing the GearsAssembly Variations Option connector SpecificationsPin Layout and Reference Circuit Robot Works Contents Introduction SET UPInstalling the software IntroductionNames of Interface Parts and Their Function Connecting the InterfaceUsing the Interface as an Infrared Signal Transmitter Points to noteSetting the serial Port Overview of the Programming OperationLets get started Panel Screen How to Read the ScreensCommand Block Factory Sensor Block FactoryPanel Screen Programminng How to Create a Sensor Block Sensor Block FactoryFrequently-Used Sensors Sensor Table Command Block FactoryHow to Create a Command Block Names of PartsPriority Order and Interrupts Sending a Program to WonderBorg SET UP ScreenTransmitting a Program To the Wonderborg Saving a ProgramSend Set Up IR signal ControlReturn Testing Programming Getting StartedProgramming Exercises Program for Exercise How to Transmit an Infrared SignalRanged Reached by the Infrared Signal PanelSoftware License Agreement Problems with Program Transmission TroubleshootingTroubleshooting Operating Problems Problems with SensorsAppendix WarrantyDay Limited Warranty Template for Legs and AntennaeFCC Statement