Linksys WPS54G manual Getting to Know the PrintServer, Bottom Panel, USB Connector-Type a

Wireless-G PrintServer

Chapter 2: Getting to Know the PrintServer

The Bottom Panel

The PrintServer’s ports and Reset button are located on the bottom panel.

	Figure 2-1: PrintServer’s Bottom Panel
Power	The Power port is where you will connect the power adapter.
Ethernet	The Ethernet port is where you will connect the PrintServer to your wired network. (This is
	optional.)
USB Printer	The USB Printer port is where you will connect the USB printer to the PrintServer.
	The USB icon (right) designates a USB port. The PrintServer comes with a USB
	cable. One end has a rectangular connector called Type A. The other end has a
	square connector called Type B. The USB cable’s Type A end connects to the
	PrintServer, and the Type B end connects to the printer.

USB Connector-Type A USB Connector-Type B

Reset Button Use the Reset Button to reset the PrintServer to its factory defaults or print a test page. The instructions are provided on the right side of this page.

IMPORTANT: Resetting the PrintServer will delete all of your settings and replace them with the factory defaults. Do not reset the PrintServer if you want to retain the settings.

To reset the factory default settings

1.Unplug the PrintServer.

2.Press and hold the Reset button. While pressing the button, plug in the PrintServer.

3.If you continue pressing the button for 10 seconds, the PrintServer will be reset to factory defaults.

To generate a diagnostic print-out

1.Ensure that both the PrintServer and the printer attached to the Printer port are ON.

2.Press the Reset button, and hold it in for 2 seconds.

3.The test page, which lists the current settings, will be printed.

PostScript printers are unable to print this page. If you have a PostScript printer on the USB Printer port, the test page will not be printed.

Chapter 2: Getting to Know the PrintServer 4

The Bottom Panel