Agilent Technologies HP 16505A, HP 16500B, HP 16500H manual Removing the Interface Module

Page 28

Servicing the Interface Module

Removing and Replacing the HP 16500H Interface Module

5Remove the screws connecting the interface module to the mainframe.

Two screws through the top of the interface module connect it to the sheetmetal plate, and four screws connect the rear plate of the interface module to the rear panel of the mainframe (see the figure below).

Removing the Interface Module

3-11

Image 28
Contents About this Manual HP 16500H Interface Module This Book See AlsoContents Contents-2 Introducing the HP 16500H Interface Module Introducing the HP 16500L LAN Interface Module Requirements Accessories SuppliedPhysical Connections LAN Support Installing the Interface Module To Install the HP 16500H Hardware Installing the Interface Module To Verify the Installation Set up the configuration menus on the HP 16500B mainframe Ethernet LAN InterfaceVerify connectivity with an echo request Mount the HP 16500B system with an NFS mountHP 16501A Expansion Frame Interface HP 16505A Protoytype Analyzer Servicing the Interface Module Verifying the Interface Module PerformanceVerify the Interface Module Performance Verify the Interface Module Performance Procedure Verify the Interface Module Performance Verify the Interface Module Performance Exit the Test System Troubleshooting an HP 16501A Expansion Frame Troubleshooting in an Ethernet LAN Environment Servicing the Interface Module Turn off the power switch located on the front panel Removing and Replacing the HP 16500H Interface ModuleRemoving the Interface Module Removing and Replacing the HP 16500H Interface Module Remove accessories from the module Returning PartsPackage the module or assemblies Seal the shipping container securely, and mark it FragileParts listed Ordering Replaceable PartsReplaceable Parts List HP 16500H Interface Module Replacment PartsPage Index CablesIndex-2 Document Warranty Product Warranty Declaration of Conformity