D-Link DES-5024 manual Rack Installation

Page 19

Fast Ethernet Switching System User’s Guide

Rack Installation

The DES-5024 can be mounted in an EIA standard size, 19-inch rack. The dimensions of the DES-5024 are 17.362 inches (441 mm) x 10.393 inches (264 mm) x 4.33 inches (110 mm). The DES-5024 can be placed in a wiring closet along with other equipment.

Follow these steps to install the DES-5024 on a rack:

1.Attach a mounting bracket to each side of the DES-5024 with the screws provided. See Figure 5.

2.Slide the DES-5024 into the rack and use the screws provided to secure the DES- 5024 to the rack. See Figure 6.

3.Connect the power cord and verify that the DES-5024 is receiving adequate power.

Installing the DES-5024

11

Image 19
Contents DES-5024 Fast Ethernet Switching System User’s Guide Link Limited Warranty Hardware North, Central, and South America Copyright Statement Wichtige Sicherheitshinweise Table of Contents Page Page Audience About This GuideOrganization Introduction FeaturesPage DES-5024 Front Panel Front PanelDES-5024 Rear Panel Rear PanelTelnet Management Management MethodsUpdating Firmware Local Console ManagementUnpacking the DES-5024 Installing the DES-5024Installation Options Install Feet on Bottom Desktop/ Shelf InstallationAttach Feet Rack Installation Attach Mounting Brackets Insert into Rack Installing Modules Remove Blank Bracket Insert Optional Module Power On Cable Specifications Connecting the DES-5024 to the NetworkCopper Cable Cable Diagram Fiber Optic Cable RS-232 Port PortsMDI-X Ports Fiber Optic PortsDES-5024 to DES-5024 Connection Connecting the DES-5024 to other Switches and HubsDES-5024 LEDs LEDsCPU Module PowerLED Link Port 10/100-TX ModuleCol Port 100BASE-FX ModuleLit Dark Act Port 1000BASE-SX ModuleManaging the DES-5024 ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None Local Console ManagementTelnet Log ∙ Default User Name D-Link ∙ Default Password D-LinkHelp Message Help MessageSpacebar Panel ConventionsConsole Program System ConfigurationUser Account Management Vlan Port Management 100BASE-FX/ 1000BASE-SX Switch Port ModuleSpanning Tree Configuration Snmp Management ConfigurationSystem Information System Configuration MenuSystem Reset Factory Reset to Default Config ValuesHardware Revision Software UpdateBoot Prom Firmware Version System Information MenuSystem Name LAN Default GatewayMAC Address System DescriptionSystem Reset System ResetFactory Reset Factory ResetFactory Reset confirmation Advantages of Store and Forward System Rate ControlDisadvantages of Store and Forward Disadvantages of Cut-Through Advantages of Cut-ThroughSoftware Update menu Software Update MenuTransfer Firmware Xmodem User Account Change Menu User Account ManagementCreate New User PasswordConfirm Password Access LevelPage Status Delete UsersDelete Page Old Password Change PasswordNew Password Page Switch Port Configuration State Switch Port Configuration MenuPhysical Priority Port StateFlow Control Spanning Tree Configuration Menu Spanning Tree ConfigurationSTA Operation Levels Root Cost Forward Delay TimeSpanning Tree Algorithm Bridge PriorityRoot Port Root BridgeSnmp Management Configuration Snmp Community String Snmp Management Configuration MenuSnmp Manager Setting Access RightLink Change Event Snmp Trap Manager SettingAuthentication Failure Cold StartPage Vlan Port Management Vlan Port Management menu Vlan Port Management MenuTrunkGroup Create New VlanNew Vlan Name Port #Page Vlan Name Delete Vlan MenuVirtual LAN Name Modify Vlan MenuTrunking Port Management menu Trunking Port Management MenuNew Trunking Group Name Create New Trunking PortName Page Trunking Port Delete Trunking PortModify Trunking Port Modify Trunking Port Trunking Port NameProblemSolution TroubleshootingPage Diagnostic LED Switch Specifications Appendix a DES-5024 Technical SpecificationsPort Specifications 10BASE-T EMI Fast Ethernet Switching System User’s Guide Performance Index Access LevelUser Name 50, 52