D-Link DES-5024 Snmp Trap Manager Setting, Cold Start, Authentication Failure, Link Change Event

Fast Ethernet Switching System User’s Guide

Status

Can be Valid or Invalid. Only communities with Valid status can access the DES-5024. Communities with Invalid status cannot access the DES-5024.

SNMP Trap Manager Setting

Enables you to enter the IP addresses of Trap Managers. Traps are messages the DES- 5024 sends out to inform trap managers of events on the network. The DES-5024 generates traps and sends them to the network manager. Trap managers are special network users who are given certain rights and access to oversee and maintain the network. This feature is available only in D-View or by using other SNMP management software.

You can specify which network managers may receive traps from the DES-5024 by creating a list of IP Addresses of the authorized network managers.

Trap managers can receive the following trap types:

∙Cold Start

∙Authentication Failure

∙Link Change Event

Cold Start

Signifies that the DES-5024 has been powered up. Software settings are reconfigured and hardware systems are rebooted. A cold start is different from a factory reset.

Authentication Failure

Signifies that an addressee (or manager/ user) on the DES-5024 is not a valid user of the DES-5024 and may have entered an incorrect community name.

Link Change Event

Signifies that the link of a port has changed from link up to link down or vice versa.

IP Address

This field is used to enter the IP Addresses of Trap Managers.

SNMP Community String

Enter the Community String of the Trap Managers in this field.

Status

The DES-5024 will not send out traps unless the status is Valid.

Follow these steps to enter the SNMP Community String:

1. Enter the name of the SNMP Community.

Managing the DES-5024 64