D-Link DES-5024 manual Local Console Management

Page 39

Fast Ethernet Switching System User’s Guide

Local Console Management

Local Console Management is always done through the RS-232 serial port and requires a direct connection between the DES-5024 and a PC. This type of management is very useful when the network is down and the DES-5024 cannot be reached by any other means.

Use Local Console Management to log into the DES-5024 for the first time. You do not need to know the IP address to log into the DES-5024 using Local Console Management. You can change all the settings and configure the DES-5024, set the IP address and perform other management functions. The management session will timeout after five minutes if you have not taken any action. Press enter a few times to refresh the screen. You will have to log in again after a timeout.

Follow these steps to begin a management session using Local Console Management:

1.Attach the male end of the RS-232 serial cable provided with the DES-5024 to the RS-232 port located at the front of the DES-5024.

2.Attach the other end to the serial port of a PC or workstation.

3.Run a terminal emulation program using the following settings:

Emulation: VT-100/ANSI compatible

BPS: 19 200

Data bits: 8

Parity: None

Stop bits: 1

Flow Control: None

Enable: Terminal keys

4.Press Enter to display the login panel.

5.Log in using the default User Name and Password. The User Name and Password are case sensitive.

User Name: D-Link

Default Password: D-Link

5. Press Enter to reach the Main menu.

Managing the DES-5024

31

Image 39
Contents DES-5024 Fast Ethernet Switching System User’s Guide Link Limited Warranty Hardware North, Central, and South America Copyright Statement Wichtige Sicherheitshinweise Table of Contents Page Page About This Guide AudienceOrganization Introduction FeaturesPage DES-5024 Front Panel Front PanelDES-5024 Rear Panel Rear PanelTelnet Management Management MethodsUpdating Firmware Local Console ManagementUnpacking the DES-5024 Installing the DES-5024Installation Options Install Feet on Bottom Desktop/ Shelf InstallationAttach Feet Rack Installation Attach Mounting Brackets Insert into Rack Installing Modules Remove Blank Bracket Insert Optional Module Power On Connecting the DES-5024 to the Network Cable SpecificationsCopper Cable Cable Diagram Fiber Optic Cable RS-232 Port PortsMDI-X Ports Fiber Optic PortsDES-5024 to DES-5024 Connection Connecting the DES-5024 to other Switches and HubsDES-5024 LEDs LEDsCPU Module PowerLED Link Port 10/100-TX ModuleCol Port 100BASE-FX ModuleLit Dark Act Port 1000BASE-SX ModuleManaging the DES-5024 ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None Local Console ManagementTelnet Log ∙ Default User Name D-Link ∙ Default Password D-LinkHelp Message Help MessageSpacebar Panel ConventionsSystem Configuration Console ProgramUser Account Management Vlan Port Management 100BASE-FX/ 1000BASE-SX Switch Port ModuleSpanning Tree Configuration Snmp Management ConfigurationSystem Information System Configuration MenuSystem Reset Factory Reset to Default Config ValuesHardware Revision Software UpdateBoot Prom Firmware Version System Information MenuSystem Name LAN Default GatewayMAC Address System DescriptionSystem Reset System ResetFactory Reset Factory ResetFactory Reset confirmation System Rate Control Advantages of Store and ForwardDisadvantages of Store and Forward Disadvantages of Cut-Through Advantages of Cut-ThroughSoftware Update menu Software Update MenuTransfer Firmware Xmodem User Account Change Menu User Account ManagementCreate New User PasswordConfirm Password Access LevelPage Delete Users StatusDelete Page Change Password Old PasswordNew Password Page Switch Port Configuration Switch Port Configuration Menu StatePhysical Port State PriorityFlow Control Spanning Tree Configuration Spanning Tree Configuration MenuSTA Operation Levels Root Cost Forward Delay TimeSpanning Tree Algorithm Bridge PriorityRoot Port Root BridgeSnmp Management Configuration Snmp Community String Snmp Management Configuration MenuSnmp Manager Setting Access RightLink Change Event Snmp Trap Manager SettingAuthentication Failure Cold StartPage Vlan Port Management Vlan Port Management menu Vlan Port Management MenuTrunkGroup Create New VlanNew Vlan Name Port #Page Vlan Name Delete Vlan MenuVirtual LAN Name Modify Vlan MenuTrunking Port Management menu Trunking Port Management MenuCreate New Trunking Port New Trunking Group NameName Page Delete Trunking Port Trunking PortModify Trunking Port Modify Trunking Port Trunking Port NameProblemSolution TroubleshootingPage Diagnostic LED Appendix a DES-5024 Technical Specifications Switch SpecificationsPort Specifications 10BASE-T EMI Fast Ethernet Switching System User’s Guide Performance Index Access LevelUser Name 50, 52