D-Link DSL-302G manual CE Mark Warning

Page 4

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

ii

Image 4
Contents DSL-302G Adsl Ethernet/USB Modem User’s Guide Page Wichtige Sicherheitshinweise CE Mark Warning Table of Contents Page VPI and VCI Settings About This User’s GuideTerminology Before You StartPage Modem Features What is ADSL?Introduction Modem Description and OperationFront Panel Rear PanelLED Indicators Packing ListHardware Installation Connect the PowerModem Location Connect Adsl LineSoftware Installation Install the Modem Configuration UtilityPage Page Page Configure the Modem Page Install the USB Driver Page Installing the PC Ethernet Client Driver Page Configure the Ethernet Client Driver Click on the Internet Protocol item in the list box Modem Diagnostics Advanced Diagnostics Factory Reset Output Power measured in dBmTechnical Specifications Data Transfer RateDSL-302G Firmware Upgrade Utility Page Product Type Warranty Period