D-Link DSL-302G manual Installing the PC Ethernet Client Driver

Page 21

Installing the PC (Ethernet Client) Driver

To install the PC (Ethernet Client) driver for a PC-attached configuration on a PC running Windows 98 SE/Windows 2000, follow the procedure below:

Note: If you have just installed the PC (USB) driver for a PC-attached Modem configuration, this procedure will automatically follow on from either of these procedures. The PC having initially detected the DSL-302G as a PC-attached USB device will now detect the DSL-302G as an Ethernet device.

Therefore, the Ethernet driver (VVB Client) now needs to be installed. If this procedure does not automatically follow, you need to reset your DSL-302G.

1.The Add New Hardware Wizard dialog box is displayed showing that it needs to install a driver for the VVB Ethernet port:

2.Click on Next to continue. The following dialog box is displayed asking you to specify how to install the driver:

3.Ensure that the first option is selected and click on Next. The following dialog box is displayed asking you to specify where the driver can be found:

Page 20 Page 22
Image 21
Page 20 Page 22
Contents DSL-302G Adsl Ethernet/USB Modem User’s Guide Page Wichtige Sicherheitshinweise CE Mark Warning Table of Contents Page About This User’s Guide VPI and VCI SettingsTerminology Before You StartPage What is ADSL? Modem FeaturesIntroduction Modem Description and OperationRear Panel Front PanelPacking List LED IndicatorsConnect the Power Hardware InstallationModem Location Connect Adsl LineInstall the Modem Configuration Utility Software InstallationPage Page Page Configure the Modem Page Install the USB Driver Page Installing the PC Ethernet Client Driver Page Configure the Ethernet Client Driver Click on the Internet Protocol item in the list box Modem Diagnostics Advanced Diagnostics Output Power measured in dBm Factory ResetData Transfer Rate Technical SpecificationsDSL-302G Firmware Upgrade Utility Page Product Type Warranty Period
Top Page Image Contents