Unpack and Inspect, Install the Adapter | D-Link DFE-570TX specification

Installation of a Server Card requires hardware installation first, then software installation. The Server Card requires a 5-volt (not 3.3-volt) PCI connection and enough room behind the connector to accommodate a full-length card. Most computers are equipped with 5-volt PCI connectors and if your computer is not, the Server Card will not fit into the slot.

Unpack and Inspect

CAUTION: Under ordinary circumstances, the Server Card will not be affected by static charge as may be received through your body during handling of the unit. In special circumstances where you may carry an extraordinarily high static charge, it is good practice to reduce the charge by touching a ground before handling the adapter card.

Open the shipping carton and carefully remove all items. In addition to this User's Guide, ascertain that you have:

∙One Ethernet Adapter Server Card.

∙Server Card Software Diskette.

Install the Adapter

1.Shut down the computer, unplug its power cord, and remove the chassis cover.

2.Insert the contact edge of the Server Card into the connector of any available PCI Bus Master expansion slot. Press the card firmly into the connector and ascertain that the card’s contacts are fully seated in the connector.