Zebra Technologies PR4T manual Installing the P4T Series Battery Pack

Installing the P4T Series Battery Pack

P4T/RP4T User Guide

Manual Introduction	RP4T Printers 35
pg.	pg.
4
P4T Overview- pg. 5	Maintenance pg. 36
Printer Preparation pg. 7	38	Troubleshooting pg.
Connecting the Printer pg. 27	43	Speci†cations pg.
Radio Regulatory Information pg. 31	Appendices pg. 46

Important • New battery packs are shipped uncharged. Remove any protective shrink- wrap and labels from a new battery pack prior to use.

Additional battery packs may be ordered using Zebra p/n AK18913-001.

If you are using an LI72 single charger or the LI72- 4 Quad Charger, you must charge the battery prior to installing it in the printer.

•.Insert the battery pack into the printer as shown in Figure 6 .

•Rock the battery pack into the printer as shown until it locks in place.

If you are using the AC adapter, you should allow the battery pack to charge completely prior to using it for the first time.

When a new battery pack is first installed, the Control Panel indicators may briefly turn on and then go off, indicating the battery is not fully charged. Refer to the Charging the Battery and Operator Controls topics in this manual.

Figure 6: Installing the P4T Series Battery Pack

Charger port for use

with the P1026943-1 AC Adapter

Insert this side of the battery pack into the bottom of the printer as shown.

Rock the battery pack until it clicks into place.

Index pg. 52

P4T Series Battery Pack

Section Continues 6