Figure 7.4-Close the Media Cover
Figure 7.5- Insert Media into Peeler
P4T/RP4T User Guide
Manual Introduction | RP4T Printers 35 |
pg. | pg. |
4 |
|
P4T Overview- pg. 5 | Maintenance pg. 36 |
Printer pg | Troubleshooting 38 |
Pull Media out of the Printer. Use alignment marks on the cover to ensure alignment. 
Close Media
Cover
Peeler Assembly.
Peeler Bar.
3.Feed the leader over the peeler bar and into the printer if you will be peeling labels as you print.
4. Press down on Peeler 
Assembly where shown and slide the media until it 
emerges .
1. Remove enough
labels from the media
roll to create a 4” [100
mm] leader.
2. Align the edge of the
leader with the index marks on the top 
cover to ensure it will pass through the peeler without wrinkling.
Preparation . 7 | pg. |
Connecting the Printer pg. 27 | Speci†cations pg. 43 |
Radio Regulatory Information pg. 31 | Appendices pg. 46 |
| Index pg. 52 |
4.Close the Media Cover:
Refer to Figure 7.4.
•Pull the media out of the printer as shown at “1.”
•Close the media cover as shown at “2”, ensuring that it latches securely into place.
•Turn the printer on or press the Feed button if the printer is already on.
•The printer will advance a short strip of media and will then be ready for printing.
5. Using the Label Peeler
Optional Step for label stock only
Refer to Figure 7.5.
The label peeler feature allows automatic separation of the printed label from its backing.
1.If you wish to use the label peeling feature, remove enough labels from the media roll to create a leader approximately 4” [100 mm.] long.
2.Align the media as it emerges from the printhead with the index marks on the top cover to ensure it will pass through the peeler assembly without wrinkling.
2.Feed the leader you created in step 1 over the peeler bar and into the peeler assembly.
3 Push on the peeler assembly where shown in Figure 6.5. Insert the leader into the label peeler as shown and push on the media roll until it emerges from the slot at the rear of the peeler assembly.
•Turn the printer on or press the Feed button if the printer is already on.
•The printer will advance a short strip of media and will then be ready for printing.
Section Continues | 19 |
