P4T/RP4T User Guide
Manual Introduction | RP4TPrinters 35 | Approved Chargers | |
| Use of chargers not approved by Zebra specifically for use with the P4T Series will void the warranty and could cause damage | ||
|
| The following table lists battery chargers approved for use with the P4T Series Printer. | |
pg. | pg. |
| to the printer or the battery pack. Zebra is not responsible for any damage to equipment caused by the improper use of |
4 |
|
| unauthorized equipment. |
|
|
| |
|
|
|
|
|
|
|
|
P4T Overview- pg. 5 | Maintenance pg. 36 |
PrinterPreparation pg. 7 | Troubleshooting 38 |
Description
LI72 single charger)
AC Adapter/US Line Cord
AC Adapter/UK Line Cord
AC Adapter/EU Line Cord
Part no
Notes.
Must be used with battery removed from printer
Must be used with battery installed in printer
Must be used with battery installed in printer
Must be used with battery installed in printer
Must be used with battery removed from printer
Description | Part no | Notes. |
|
| |
|
| |
Adapter/Right | N/A | |
Angle |
|
|
1.Full part number is determined by the AC main adapter appropriate for the region of intended use. Consult your Zebra sales represenetative or the factory for the appropriate part number.
pg. |
Single Battery Charger
Figure 2: LI72 Single Charger
The LI72 Charger
LI72 charger is a wall mounted fast charger with a universal 110 to 230,
Connecting the Printer pg. 27 | Speci†cations pg. 43 |
Radio Regulatory Information pg. 31 | Appendices pg. 46 |
| Index pg. 52 |
Yellow Green
LI72 Charger
AT17696-xx
with most international standards. This charger is intended for use with the P4T Series printers which are equipped with Lithium Ion
Full part numbers are determined by the AC mains connectors. Consult Zebra or your authorized
The LI72 will charge a battery pack as fast as its charge level will allow, and then switch over to a maintenance charge to keep the charge at its maximum.
Section Continues
