D-Link DE-528CT manual Hardware Installation, Insert the adapter into an

Page 15

DE-528CT Ethernet Adapter / User s Guide

3

HARDWARE INSTALLATION

CAUTION: To prevent the damage to the product due to ESD, please use wrist straps during the installation and maintenance.

Installation of a DE-528CT Ethernet adapter requires two steps:

Step 1 Insert the adapter into an

expansion slot

1.Shut down the computer, unplug its power cord, and remove the chassis cover.

2.Insert the card into the connector of any open PCI Bus I/O expansion slot. Ascertain that the card is fully seated in the expansion slot connector.

3.Install the bracket screw which secures the card to the computer chassis.

4.Replace the computer s chassis cover.

Image 15
Contents Model DE-528CT Page Limited Warranty Limitation of Liability Page Page Trademarks Page Table of Contents Specifications Cable Specifications Device Drivers Introduction FeaturesGeneral steps to set up/configure a DE-528CT card DE-528CT Ethernet Adapter / User s Guide Page Insert the adapter into an Hardware InstallationNetwork Cable Connections Thin Coaxial Cable Page Software Installation Page Starting the Setup and Diagnostic Program Configuration DiagnosticsConfiguring DE-528CT Boot ROM Installation Page LED Indicators Trouble ShootingPage PCI SpecificationsPage Cable for RJ-45 connector for 10BASE-T network Cable SpecificationsPage Drivers available for the following systems/protocols Device DriversPage DE-528CT Ethernet Adapter / User s Guide Page DE-528CT Ethernet Adapter / User s Guide Page 10/100 Fast Ethernet Switch User s Guide Page Offices Registration Card Would you recommend your D-Link product to a friend?