D-Link DE-528CT manual Boot ROM Installation

Page 23

DE-528CT Ethernet Adapter / User s Guide

6

BOOT ROM INSTALLATION

The optional Boot ROM device allows you to connect a diskless workstation to the network. Follow the steps to install your Boot ROM.

1.Insert the Boot ROM into the socket on the adapter.

2.Run the SETUP.EXE program. Choose Set Up New Configuration , choose Boot ROM Size , then choose the Boot ROM Enabled.

3.Restart the computer.

Note: Also refer to the Boot ROM installation procedures provided by your Network Operating System.

Image 23

Contents Model DE-528CT Page Limited Warranty Limitation of Liability Page Page Trademarks Page Table of Contents Specifications Cable Specifications Device Drivers Introduction FeaturesGeneral steps to set up/configure a DE-528CT card DE-528CT Ethernet Adapter / User s Guide Page Insert the adapter into an Hardware InstallationNetwork Cable Connections Thin Coaxial Cable Page Software Installation Page Starting the Setup and Diagnostic Program Configuration DiagnosticsConfiguring DE-528CT Boot ROM Installation Page LED Indicators Trouble ShootingPage PCI SpecificationsPage Cable for RJ-45 connector for 10BASE-T network Cable SpecificationsPage Drivers available for the following systems/protocols Device DriversPage DE-528CT Ethernet Adapter / User s Guide Page DE-528CT Ethernet Adapter / User s Guide Page 10/100 Fast Ethernet Switch User s Guide Page Offices Registration Card Would you recommend your D-Link product to a friend?