D-Link DE-528CT manual Trouble Shooting, LED Indicators

Page 25

DE-528CT Ethernet Adapter / User s Guide

Appendices

A

TROUBLE SHOOTING

This section describes reasons for some adapter s failures and the actions to be taken to resolve the problems.

Connection failure, and unshielded twisted pair(UTP) cable was used. Action: Verify the UTP cable is firmly a attached.

Connection failure, and coaxial cable was used.

Action: Verify the coaxial cable is properly terminated..

B

LED INDICATORS

ACTIVE

Flashing green indicates that the adapter is transmitting or receiving.

LINK

Steady green indicates good linkage between the DE-528CT and its supporting hub.

Image 25

Contents Model DE-528CT Page Limited Warranty Limitation of Liability Page Page Trademarks Page Table of Contents Specifications Cable Specifications Device Drivers Introduction FeaturesGeneral steps to set up/configure a DE-528CT card DE-528CT Ethernet Adapter / User s Guide Page Insert the adapter into an Hardware InstallationNetwork Cable Connections Thin Coaxial Cable Page Software Installation Page Starting the Setup and Diagnostic Program Configuration DiagnosticsConfiguring DE-528CT Boot ROM Installation Page LED Indicators Trouble ShootingPage PCI SpecificationsPage Cable for RJ-45 connector for 10BASE-T network Cable SpecificationsPage Drivers available for the following systems/protocols Device DriversPage DE-528CT Ethernet Adapter / User s Guide Page DE-528CT Ethernet Adapter / User s Guide Page 10/100 Fast Ethernet Switch User s Guide Page Offices Registration Card Would you recommend your D-Link product to a friend?