D-Link DE-528CT manual Cable Specifications, Cable for RJ-45 connector for 10BASE-T network

Page 29

DE-528CT Ethernet Adapter / User s Guide

D

CABLE SPECIFICATIONS

The DE-528CT Ethernet adapter has three connector alternatives. Each connector requires a different cable. This section describes the various cable s specifications:

Cable for RJ-45 connector for 10BASE-T network

Cable type	STP/UTP with 2 twisted pairs of 22,
	24 or 26 AWG
Twists per foot	2 to 3(min.)
Nominal impedance	100 ohms
Maximum cable length	328 feet( 100 m)

Cable for thin coaxial BNC connector for 10BASE2 network
Cable type	RG-58 A/U or RE-58C/U
Minimum distance	0.5m(between two nodes.)
Maximum segment length	600feet(185m)
Maximum nodes per segment	30

Image 29

Contents Model DE-528CT Page Limited Warranty Limitation of Liability Page Page Trademarks Page Table of Contents Specifications Cable Specifications Device Drivers Introduction FeaturesGeneral steps to set up/configure a DE-528CT card DE-528CT Ethernet Adapter / User s Guide Page Insert the adapter into an Hardware InstallationNetwork Cable Connections Thin Coaxial Cable Page Software Installation Page Starting the Setup and Diagnostic Program Configuration DiagnosticsConfiguring DE-528CT Boot ROM Installation Page LED Indicators Trouble ShootingPage PCI SpecificationsPage Cable for RJ-45 connector for 10BASE-T network Cable SpecificationsPage Drivers available for the following systems/protocols Device DriversPage DE-528CT Ethernet Adapter / User s Guide Page DE-528CT Ethernet Adapter / User s Guide Page 10/100 Fast Ethernet Switch User s Guide Page Offices Registration Card Would you recommend your D-Link product to a friend?