Adaptec USB2connect Host Bus Adapter manual Installing USB2connect

Page 10

Installing USB2connect

4Replace the slot cover screw. When installed properly, the card should be level with the expansion slot.

5Close the computer cabinet and reattach the power cord.

The USB2connect AUA-5100 adapter shares one internal and external connector so that only five can be used at one time. The default setting is that all external connectors are Enabled, and the internal connector is Disabled. To switch these settings so that the internal port is enabled, set the jumpers according to the figure below.

Changing jumpers on the AUA-5100:

jumpers

External Port Enabled (default)

All 5 external ports enabled

disabled

Internal Port Enabled

jumpers

 

 

enabledenabled

 

disabled

 

These 4

 

ports

 

enabled

5

Image 10
Contents USB2connect Host Bus Adapter Copyright Adaptec Customer Support Iii Regulatory Compliance Statements Overview USB2connect Host Bus AdapterUSB2connect Driver Information Other Requirements Contents of BoxRequired Operating Systems Goal of This GuideInstalling USB2connect Installing USB2connect Installing the Windows Drivers Windows MeInstalling the Windows Drivers USB2connect User’s Guide Windows USB2connect User’s Guide Installing the Windows Drivers USB2connect User’s Guide Windows 98 SE Select The updated driver recommended. Click Next Installing the Windows Drivers USB2connect User’s Guide Installing the Windows Drivers Installing the Macintosh Driver Connecting USB Devices DevicesTroubleshooting Troubleshooting