Adaptec USB2connect Host Bus Adapter manual Regulatory Compliance Statements

Page 5

Regulatory Compliance Statements

Federal Communications Commission Radio Frequency Interference Statement

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. However, if this equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Use a shielded and properly grounded I/O cable and power cable to ensure compliance of this unit to the specified limits of the rules.

European Union Compliance Statement

This Information Technology Equipment has been tested and found to comply with the following European directives:

EMC Directive 89/336/EEC, as amended by 92/31/EEC and 93/68/EEC

EN 50081-1 (1992)

EN55022 (1994) Class B

EN 50082-1 (1992)

EN61000-4-2 (1998)

EN61000-4-3 (1998)

EN61000-4-4 (1995)

EN61000-4-5 (1995) Surges

EN61000-4-6 (1996) Conducted immunity

EN61000-4-11 (1994) Supply dips of variation

Australian/New Zealand Compliance Statement

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to the Australian/New Zealand standard AS/NZS 3548 set out by the Spectrum Management Agency.

Canadian Compliance Statement

This Class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matérial brouilleur du Canada.

Japanese Compliance (Voluntary Control Council Initiative)

iv

Image 5
Contents USB2connect Host Bus Adapter Copyright Adaptec Customer Support Iii Regulatory Compliance Statements USB2connect Host Bus Adapter OverviewUSB2connect Driver Information Required Operating Systems Contents of BoxOther Requirements Goal of This GuideInstalling USB2connect Installing USB2connect Windows Me Installing the Windows DriversInstalling the Windows Drivers USB2connect User’s Guide Windows USB2connect User’s Guide Installing the Windows Drivers USB2connect User’s Guide Windows 98 SE Select The updated driver recommended. Click Next Installing the Windows Drivers USB2connect User’s Guide Installing the Windows Drivers Installing the Macintosh Driver Devices Connecting USB DevicesTroubleshooting Troubleshooting