3Com 3C319 Running the AutoLink Program, Insert TokenDisk diskette #1 in the floppy drive and type

Running the AutoLink Program 3-3

1Make a backup copy of the CONFIG.SYS file. Type: copy config.sys config.old [Enter]

2Edit the memory manager device statement in the CONFIG.SYS file to exclude the memory range that the 3C319 NIC uses.

The statement should be similar to the following:

DEVICE=C:\WINDOWS\EMM386.EXE NOEMS X=CC00-CDFF X=D800-DBFF

where X stands for exclude, followed by the NIC’s memory range. See Chapter 5, “Configuring the NIC Manually,” for additional memory ranges.

Refer to your operating system manual for additional instructions and information on using the memory manager.

3Save the CONFIG.SYS file and exit the text editor.

4Reboot the PC.

Next, load the NetWare DOS ODI client driver by running the AutoLink program, as described in the next section.

Running the AutoLink Program

The AutoLink program loads the NetWare DOS ODI client driver and automatically configures the 3C319 NIC. To run the AutoLink program, follow these steps:

1Insert TokenDisk diskette #1 in the floppy drive and type:

a:[Enter]

2Type:

autolink [Enter]

The first time you use the installation software, the 3Com software license appears.