3Com 3C319 manual Changing the Test Setup, Press Enter to start the tests

9-6CHAPTER 9: TROUBLESHOOTING NIC INSTALLATION

5Press [Enter] to start the tests.

Each test runs once unless you specify otherwise. The test results are displayed on the screen with “Passed” or “Failed” in the Results column.

To run the tests continuously, select the Continuous option in the Test Setup dialog box, as described in the next section, “Changing the Test Setup.”

Changing the Test Setup

To change the test parameters, follow these steps:

1Select Test Setup in the Run Tests dialog box and press [Enter].

The Test Setup dialog box appears, as shown in Figure 9-4.

Diagnostic and Manual Configuration Program Version 2.0 Quit Install Test View Select

F1=Help

Group Select

Group 1

Group 2

Repetitions

(.) [1 ]Times

Continuous

Errors

[X] Halt on Error

Test Setup

	Group 1 Tests
MMIO Register Write/Read Test			*Enabled
AIP Checksum Test			*Enabled
Shared RAM Boundary/Domain Test			*Enabled
Shared RAM Write/Read Test			*Enabled
Timer Test			*Enabled
Open NIC for Ring Operation Test			*Enabled
Ring Operations Test			*Enabled
Close NIC Test			*Enabled
Defaults	Enable Group		Disable Group
File Options...		OK	Cancel

[−↓]=Select a Test Group to View [Alt]+<Highlighted Key>=Execute Function

[TAB]=Next Field [SHIFT+TAB]=Previous Field [F1]=Help [ESC]=<Cancel>

Figure 9-4Test Setup Dialog Box

2Press [Tab] to move from field to field and select any field within the Test Setup dialog box.

Within the Group Select area, use the arrow keys to select Group 1 or Group 2. Use the Enable Group or Disable Group options to enable or disable a group of tests.