adapter BIOS is enable , you should assign a right BIOS address (JP8 and JP9) and port address (JP7) at the same time.
Host Adapter BIOS Disabled | = Open |
Host Adapter BIOS Enabled* | = Close |
(* means default setting) |
|
SCSI Hard Disk Drive Connector (CN1)
The SCSI hard disk drives require a
1.Connect one end of the cable to CN1. Make sure that the red (or blue) wire corresponds to pin 1 on the connector, which is labeled on the board .
2.Plug the other end of the cable into the SCSI device, with pin 1 on the cable corresponds to pin 1 on the drive.
Chapter 2 Hardware Installation 17