Adaptec PCM-3420, PC/104 manual

Page 30

the host adapter and other hardware in your computer. You can fix this zby changing the hardware resource settings.

Q:What do I need to do if I change or upgrade my host adapter ?

A:

1.Open the Control Panel, double-click on system, and click the Device Manager tab.

2.Double-click the SCSI Controllers icon, select the name of the old host adapter, and click remove.

3.Turn off the computer and physically remove the currently installed host adapter.

4.Turn the computer On. If the host adapter supports Plug and Play, Windows will install and configure it automatically. Other- wise, run Add New Hardware to make sure the new driver is loaded.

Q:If I am running under Windows 95, do I need lines for the Adaptec real mode ASPI drivers and mscdex in my config.sys and autoexec.bat files?

A:Usually, you do not need to use these real mode ASPI drivers, because the new Windows miniport drivers support most SCSI host adapters and SCSI Devices. However, you need to load the drivers (including mscdex, if you have a CD-ROM drive) if any of the following is true :

lYou are running in MS-DOS mode.

lYou are using a scanner or another SCSI device with config.sys- based or autoexec.bat-based drivers, such as HP's sjiix.sys.

lYou have an older model SCSI CD-ROM drive that Windows 95 does not support.

lYou are using a CD-Recorder drive (however, some newer models of CD-Recorder drivers can use the embedded Windows miniport drivers)

To install the Adaptec EZ-SCSI DOS drivers, click the Start Button and select Restart the computer in MS-DOS mode. When the DOS prompt appears, follow the Quick Start instructions for DOS on previous section.

Q:My CD-ROM driver doesn’t work properly under Windows 95 ?

A:Some older models of SCSI CD-ROM drivers are not compatible with

2 4 PCM-3420 User's Manual

Image 30
Contents PCM-3420 PC/104 Fast SCSI-2 Module Page Copyright Notice AcknowledgementsPacking Set Contents Appendix a Installing PC/104 Modules Appendix B Pin AssignmentsAppendix C Glossary of Technical Terms39 General Information Product Highlights IntroductionFeatures Peripheral Device SupportSpecifications Technical SpecificationsPhysical and Environmental Specifications Board layout Page Hardware Installation Jumpers and Connectors Jumpers Label FunctionJP6 JP7 JP2 Locating Jumpers & Connectors Setting Jumpers Precautions Installing PCM-3420 ModuleFactory Default Settings Jumper Configuration Reference JP2SD0 SD1 SD2 DMA DC1 DC2 This jumper block provides six major PCM-3420 operation mode CC000h CFFFFh Scsi Hard Disk Drive Connector CN1 Page EZ-SCSI Quick Reference System Requirements for Full Installa- tion Quick Start InstructionsWindows 95 or Windows NT Windows/Windows for Workgroups DOSTroubleshooting Tips Scsi Device TroubleshootingWindows 95/Windows NT Troubleshooting General Information Page General Information DOS and Windows 3.1x Aspi Managers Information for DOS/Windows 3.1x UsersDOS and Windows 3.1x Device Driver DOS Formatting UtilitiesLow-level Formatter scsifmt Formatter and Partitioner afdisk Removable Media Manager rmvtool Page Installing PC/104 Modules Installing PC/104 modules PC/104 Module Mounting Diagram Page Pin Assignments PC/104 Connectors J1 , J2 Pin SignalInternal SCSI-2 Connector CN Page Glossary of Technical Terms Adaptec EZ-SCSI Termpwr GND Synchronous Transfer Bios Devicedriver DOS Partition Chronous Full Scsi IRQ Narrow Scsi device as opposed to Wide Scsi device Port I/O Address Scsi Device Taggedqueuing Termination Page Appendix C Glossary of Terms