Abocom WU5205 user manual Link Status Tab

Page 64

Link Status Tab

Status

Extra Info

Channel

Authentication

Encryption

Network Type

IP Address

Sub Mask

Default Gateway

Link Quality

Signal Strength 1

Noise Strength

Shows the current connected AP SSID and MAC address. If there is no connection existing, it will show Disconnected.

Shows the link status and Tx power percentage.

Shows the current channel in use.

Authentication mode used within the network, including Unknown, Open, WPA-PSK, WPA2-PSK, WPA and WPA2.

Shows the encryption type currently in use. Valid value includes WEP, TKIP, AES, and Not Use.

Network type in use, Infrastructure for BSS, Ad-Hoc for IBSS network.

Shows the IP address information.

Shows the Subnet Mask information.

Shows the default gateway information.

Shows the connection quality based on signal strength and TX/RX packet error rate.

Shows the Receiving signal strength, you can choose to display as percentage or dBm format.

Shows the noise signal strength in the wireless environment.

- 58 -

Image 64

Contents 802.11 b/g/n Micro Mini Wireless LAN USB2.0 Adapter Federal Communication Commission Interference Statement CE Statement Table of Contents Utility Configuration for Windows Vista Soft AP Mode Introduction Windows 2000/XP Installation Configuration Tool Choose to use our configuration utility Page Install the Hardware Windows Vista Installation Page Verification Network Connection Utility Configuration for Windows 2000/XP Profile Profile TabProfile Name SsidSystem Configuration tab Page Authentication and Security tab Page 802.1x tab EAP Method Tunnel Authentication ID\PASSWORD tab Client Certification tabDelete Edit Activate Server Certification tabNetwork Network TabGeneral ConnectWPS CXX Link Status 802.11nStatus Link Status TabExtra Info Advanced Advanced Tab Transmit StatisticsCTS WMM / QoS Receive StatisticsWMM Enable WMM- Power Save EnableDirect Link Setup Enable Timeout ValueWPS AP List Apply Tear DownInformation PIN Code Config Mode Detail Rotate Disconnect Export ProfileRadio On/Off DeletePIN PBCAbout Utility Menu List Config ConfigSecurity Setting Use Mac AddressPage Page Access Control Access ControlAccess Policy Access ListPower Saving Mode MAC TableAdd Delete Remove All Apply MAC TableEvent Log Event LogEvent Time Records the event time Yy/mm/dd-hhmmss Message Transmit Statistics About Utility Configuration for Windows Vista Profile Tab System Configuration tab Page Authentication and Encryption tab Page 802.1x tab EAP Method Tunnel Authentication ID/ Password Identity and password for server Server Certification tab Delete Edit Activate Network Tab Sorted byWPS CXX Link Status Link Status Tab Transmit Receive Link Speed Throughput Enable TCP Window Size Fast Roaming at Apply Transmit Statistics TabReceive Statistics Tab WMM- Power Save Enable Direct Link Setup Enable MAC Address WMM/QoS TabTimeout Value Apply Tear Down WPS TabRescan Information PIN Code Config Mode Detail Connect Rotate Disconnect PIN PBC Export Profile DeleteWPS Associate IE WPS Probe IE Progress Bar Status Bar Utility Menu List AP name of user type. User also can click Use Mac Use Mac Address Security SettingAddress button to display it Page Page Access Control MAC Table Event Log Statistics About Uninstallation for Windows Page Uninstallation for Windows Vista