Beacon (ms)
TX Power
Idle
No forwarding among wireless clients
Hide SSID
Allow BW 40MHz
Tx BURST
Default
Apply
WEP Key: Only valid when using WEP encryption algorithm. The key must match with the AP’s key. There are two formats to enter the keys.
•Hexadecimal (128bits): 26 Hex characters.
•ASCII (128bits): 13 ASCII characters.
Show Password: Check this box to show the password you entered.
The time between two beacons. The system default is 100 ms.
Manually force the AP transmits power from the pull down list 100%, 75%, 50%, 25% and lowest. The system default is 100%.
It represents that the AP will idle after few seconds. The time must be set between 60~3600 seconds. Default value of idle time is 300 seconds.
No beacon among wireless client, clients can share information each other. The system default is no forwarding.
Do not display AP name. System default no hide.
Click to disable this function. Default is enabled.
Check to enable this function.
Use the system default value.
Click to apply the above settings.
- 38 -