Acer Modemconte user manual Section Five Result Codes

Page 14

S13	Reserved
S14	Echo, response, dialing,	Bit-mapped
	originate/answer
S15	Reserved
S16	Modem test options	Bit-mapped
S17	Reserved
S18	Modem test timer	0-255/seconds	0
S19	Reserved
S20	Reserved
S21	Auto retrain, RTS/CTS,	Bit-mapped
	DTR, DCD, DSR
S22	Speaker and response	Bit-mapped
S23	RDL, DTE data rate,	Bit-mapped
	parity,and guard tone
S24	Reserved
S25	DTR delay	0-100/seconds	5
S26	RTS/CTS delay interval	0-255/0.01 second	1
S27	Async operation, Line	Bit-mapped
	type
S36	Negotiation Fallback	0-7	7
S37	Maximum line speed	0-11	0
S38	Forced hangup delay	0-255	20
S46	Select data compression	136, 138	138
S48	Feature negotiation	0, 7, 128	7
S49	Buffer lower limit	0-255	10
S50	Buffer upper limit	0-255	200
S63	Leased Line carrier level	0-15	0
S82	Break Signaling	3, 7, 128	128
S86	Connection failure code 0, 4, 9,10, 12-14
S98	Speakerphone squelch timer	0-255/.001second	10

Section Five - Result Codes

BASIC RESPONSE CODES

OK	0	CONNECT	1
RING	2	NO CARRIER	3
ERROR	4	CONNECT 1200	5
NO DIALTONE	6	BUSY	7
NO ANSWER	8	CONNECT 2400	10
CONNECT 4800	11	CONNECT 7200	24
CONNECT 9600	12	CONNECT 12000	25
CONNECT 14400	13	CONNECT 19200	14
CONNECT 38400	28	CONNECT 57600	29
CONNECT 1200/75	22	CONNECT 75/1200	23

EXTENDED RESPONSE CODES

13

Image 14

Contents Contents Section One Introduction Section Two InstallationHardware Installation Unpacking Your ModemPlug and Play Fasten the retainingSoftware Installation/Configuration Using Fax, Voice, and Speakerphone Capabilities of the ModemWhere To Go From Here Testing Your Modem After InstallationUsing Your Modem Executing CommandsBold text Command Function Command StructureBasic AT Commands Bell modeMedium speaker volume Commands are not echoedCommands are echoed Pulse dialingExtended AT Commands Force DSR Signal High on Guard tone disabledModem connects using MNP or RTS/CTS flow control22bis auto-retrain enabled Enable Trellis Coding @On or reset Zn=xFax Class 2 Commands Voice Mode Commands Section Four S Registers Speakerphone CommandsRegister Function Range/units Default S RegistersSection Five Result Codes Modem does not dial Section Six TroubleshootingModem does not respond to commands High pitch tone is heard whenever you answer the phone Modem dials but does not connectModem makes a connection but no data appears on your screen Section Eight Support and Service Modem exhibits poor voice record or playbackFCC Class B Statement Section Nine FCC , DOC & Other NoticesFCC Compliance DOC Compliance Information Disclaimer, Copyright, And Other NoticesGZ/DR Version