Enable Trellis Coding @, On or reset, Zn=x

	&T8	Perform Local Analog Loopback Test and
		Self-Test
&U_	&U0	Enable Trellis Coding @ V.32
	&U1	Disable Trellis Coding @ V.32
&V_	&V0	Displays Active and Stored Profile 0
	&V1	Displays Active and Stored Profile 1
&W_	&W0	Stores the active profile as Configuration
		Profile 0
	&W1	Stores the active profile as Configuration
		Profile 1
&Y_	&Y0	Configuration Profile 0 active upon Power
		on or reset
	&Y1	Configuration Profile 1 active upon Power on
		or reset
&Zn=x	n=0-3	Store telephone number x into non-volatile
		RAM
%E_	%E0	V.22bis auto-retrain disabled
	%E1	V.22bis auto-retrain enabled

3.5	MNP/V.42/V.42bis Commands
%An	n=0-	Set auto-reliable fallback character to n (where
	127	n = 0 to 127,ASCII). Requires the \C2 setting
%C_	%C0	Disable MNP Class 5 data compression
	%C1	Enable MNP Class 5 data compression
%D_	%D0	512 byte dictionary for V.42bis
	%D1	1Kbyte dictionary
	%D2	2 Kbyte dictionary
\C_	\C0	Do not buffer data during LAPM/MNP
		handshaking
	\C1	Buffer all data for 4 seconds, until receiving
		200 characters or until a packet is detected
	\C2	Do not buffer data; switch to normal mode
		when fallback character is detected
\G_	\G0	Disable DCE flow control
	\G1	Enable DCE flow control
\N_	\N0	Normal data-link only
	\N1	Direct data-link only
	\N2	MNP data link only
	\N3	MNP/Normal data link
	\N4	V.42 data link only
	\N5	V.42/Normal data link

Enable Trellis Coding @ V.32