Acer Modemconte user manual Plug and Play, Fasten the retaining

Page 3
Figure 2-3
PHONE
LINE
MIC
Figure 2-2
Mic/Speaker connector

slot,andthenremovethe slot cover (refer to Fig- ure 2-1).

4.Carefully slide the in- ternal modem into the slot you have chosen, applying even pressure until the modem is com- pletely seated in the slot.

5.Fasten the retaining

bracket with the screw from the slot cover.

Make sure the modem is properly aligned. Store the slot cover for future use.

6.Connect the computer sound card's micro-

phone/speaker interconnector plug to the modem's mic/speaker connector (See fig- ure 2-2).

7.Replace the computer cover and plug in your computer.

8. Connect the telephone cable from the modem'sLINE connector (See figure 2-3) to the telephone wall jack.

9.Optionally connect your telephone to the modem'sPHONE connector (See figure 2-3).

10.Connect the microphone plug into the MIC jack (See figure 2-3).

11.Connect your powered speaker(s) into the Line Out jack of the sound card.

12.Turn your computer on. Your modem is now installed.

2.3 Plug and Play

Your modem supports Plug and Play (PnP) and can easily be configured using any Plug and Play compliant PC. Your PC is PnP compliant if you have: 1) an operating system that supports Plug and Play, and 2) PnP BIOS/chipset.

In a PnP compliant operating system (e.g. Windows ® 95), follow the instructions included with the operating system to configure Plug and Play cards.

On Acer pre-configured systems with this modem and Windows 95 software, this modem has been set to:

'MODEM'

Sierra 14.4 Data Fax Voice SQ3230

2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Contents Unpacking Your Modem Section Two InstallationHardware Installation Section One IntroductionFasten the retaining Plug and PlayUsing Fax, Voice, and Speakerphone Capabilities of the Modem Software Installation/ConfigurationExecuting Commands Testing Your Modem After InstallationUsing Your Modem Where To Go From HereBell mode Command StructureBasic AT Commands Bold text Command FunctionPulse dialing Commands are not echoedCommands are echoed Medium speaker volumeExtended AT Commands RTS/CTS flow control Guard tone disabledModem connects using MNP or Force DSR Signal High onZn=x Enable Trellis Coding @On or reset 22bis auto-retrain enabledFax Class 2 Commands Voice Mode Commands S Registers Speakerphone CommandsRegister Function Range/units Default Section Four S RegistersSection Five Result Codes Section Six Troubleshooting Modem does not respond to commandsModem does not dial Modem dials but does not connect Modem makes a connection but no data appears on your screenHigh pitch tone is heard whenever you answer the phone Modem exhibits poor voice record or playback Section Eight Support and ServiceSection Nine FCC , DOC & Other Notices FCC ComplianceFCC Class B Statement Disclaimer, Copyright, And Other Notices DOC Compliance InformationGZ/DR Version
Top Page Image Contents