Acer Modemconte user manual Pulse dialing, DS=n, Commands are not echoed, Commands are echoed

P	pulse dialing
T	touch-tone dialing
W	wait for second dial tone

,pause

@ wait for five seconds of silence ! flash

; return to Command Mode after dialing : return to Command Mode after dialing

and maintain connection

DS=n		Dial one of the four telephone numbers (n=0-
		3) stored in the modem’s non-volatile memory
E_	E0	Commands are not echoed
	E1	Commands are echoed

+++TIES Escape Characters - Switch from Data Mode to Command Mode

H_	H0	Force modem on-hook (hang up)
	H1	Force modem off-hook (make busy)
I_	I0	Display 14400
	I1	Display 000
	I2	Internal memory test
	I3	Firmware revision number
	I4	Configuration settings
	I6	DSP
L_	L0	Low speaker volume
	L1	Low speaker volume
	L2	Medium speaker volume
	L3	High speaker volume
M_	M0	Internal speaker off
	M1	Internal speaker on until carrier detected
	M2	Internal speaker always on
	M3	Internal speaker on until carrier detected and
		off while dialing
N_	N0	Line speed set by register S37.
	N1	Originate with automatic rate negotiation
		starting at S37 setting, answer at any speed.
	N2	Adds V.23 to N1
	N3	Originating line speed set via register S37
	N4	Same as N3
	N5	Originate with automatic rate negotiation
		starting at S37 setting, Anwer only at S37
		setting
O_	O0	Return to Data Mode

6