Acer Modemconte user manual Software Installation/Configuration

Page 4

COM 1, IRQ 4

'MODEM VOICE'

Sierra 3230 (Voice) DMA 3, IRQ 10

2.4 Software Installation/Configuration

You are now ready to install and configure the commu- nication software. Refer to your software manual for instal- lation procedures. Your software must be configured to communicate with the modem on the same COM port and IRQ line used by the modem.

We suggest the following communication parameters when you first use your data communication software. Consult the software manual for information on using these and other parameters/features.

38,400 bps; 8 data bits; no parity; 1 stop bit; RTS/ CTS flow control set to “on;” initialization string: AT&F

The commands used by the modem are compatible with the command set used by the “ Hayes V-series Ultra Smartmodem 14400” modems, select this modem type in your data communications software. Select a “ Generic Class 2” modem type in your FAX software and select a “ Sierra” modem type in your voice software.

2.5Using Fax, Voice, and Speakerphone Capabilities of the Modem

Your modem has built-in advanced FAX, Voice, and Full Duplex Speakerphone functions. These functions are accessed through software. Please consult your FAX/Voice/ Speakerphone software manual about procedures on using these functions. Note that the modem's FAX/Voice/Speaker- phone commands are used by the software to implement these functions and are not designed to be used as stand- alone AT commands.

Voice functions include recording and playback of voice prompts (files). You may record or playback voice with your modem by attaching a telephone to the RJ-11 jack marked "PHONE" or by attaching a microphone to the MIC jack located on the back of the modem bracket. Then follow instructions in the FAX/Voice/Speakerphone software on recording and playback of voice prompts.

3

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Contents Section Two Installation Hardware InstallationSection One Introduction Unpacking Your ModemPlug and Play Fasten the retainingSoftware Installation/Configuration Using Fax, Voice, and Speakerphone Capabilities of the ModemTesting Your Modem After Installation Using Your ModemWhere To Go From Here Executing CommandsCommand Structure Basic AT CommandsBold text Command Function Bell modeCommands are not echoed Commands are echoedMedium speaker volume Pulse dialingExtended AT Commands Guard tone disabled Modem connects using MNP orForce DSR Signal High on RTS/CTS flow controlEnable Trellis Coding @ On or reset22bis auto-retrain enabled Zn=xFax Class 2 Commands Voice Mode Commands Speakerphone Commands Register Function Range/units DefaultSection Four S Registers S RegistersSection Five Result Codes Modem does not respond to commands Section Six TroubleshootingModem does not dial Modem makes a connection but no data appears on your screen Modem dials but does not connectHigh pitch tone is heard whenever you answer the phone Section Eight Support and Service Modem exhibits poor voice record or playbackFCC Compliance Section Nine FCC , DOC & Other NoticesFCC Class B Statement DOC Compliance Information Disclaimer, Copyright, And Other NoticesGZ/DR Version
Top Page Image Contents