1
INSTALLATION
CONNECTING THE TWO UNITS
SIM2’s RTX system is made up of the following components (Fig.1):
•Display
•DigiOptical Image Processor
•remote control
•DigiOptical Image Processor power supply unit
•three power cables for the Display
•three power cables for the DigiOptical Image Processor
•triple fibre optic cable for linking the DigiOptical Image Processor and the Display
•four 1.5 V
•User and installation manual
If any accessories are missing, contact your Dealer as soon as possible.
Display
Instruction
Manual
I
O
Alimentatore
DigiOptical Image
DigiOptical
ProcessorImage Processorpower supply unit
DI |
|
|
|
GIO | PTIC |
|
|
| ALIM | AGE |
|
|
|
| |
|
| PRO | CESSOR |
|
|
|
DigiOptical | |
fibre optic cable | Image Processor |
Remote Control
1.5 V AAA- 
type batteries
Power cables
Europe, UK, US (x2)
Fig. 1
The RTX system consists of two separate units (the DigiOptical Image Processor and the Display), each of which is equipped with a power cable; the two units are interconnected by a 20 m fibre optic cable.
The ideal location for the DigiOptical Image Processor is on a cabinet shelf or on a rack (dimensions compatible with a standard 19" rack). Make sure that the support surface is stable and that the unit has sufficient space around it for ventilation purposes (at least 3 cm).
The unit is connected to the mains via an external power supply unit with an output of +7 Vdc; the unit’s main power switch is on the power supply unit.
Connect the power supply unit output cable to the POWER socket located on the rear panel (Fig. 4).
Use exclusively the power supply unit provided with the system or an alternative power supply unit expressly approved by SIM2.
The Display is designed to stand on the floor. Place the Display on a flat, level surface where it has sufficient space for ventilation; to prevent glare and reflections, avoid places exposed to direct sunlight or intense light sources.
The mains power input socket and the power switch are both located on the rear panel.
Adjust the rear feet to obtain the optimum viewing angle in accordance with the distance and height of the viewing position in front of the Display (Fig. 2).
The system can be fully controlled using the supplied IR
Fig. 2
(infrared) remote control handset. There is a single remote control for both the DigiOptical Image Processor and the Display; the remote control can be directed towards either unit since they are both equipped with an IR sensor.
The connection between the two units is made with a single cable containing three fibre optic cables each terminating in an LC connector. The standard cable length of 20 m will be sufficient for most installation requirements.
Tappo di
Pprotezionective cap
Ferrule
Separation point
Connector
Fibre
Fig. 3
Cable
6
