JVC GV-DS1 Cannot capture video data, With the desired counter, Number, Counter cannot be reset

TROUBLESHOOTING (cont.)		37
Problem	Cause	Page
Cannot capture video data	⬤ There may be a slight difference between
with the desired counter	the counter of the video image that you
number.	want to capture and the Index image data/	25 – 28
	Full image data captured in the computer.
	This is not a malfunction.
Counter cannot be reset.	⬤ Counter reset is not available with digital	30
	camcorders.
Program capture suddenly	⬤ When you start program capture at the
stops.	beginning of the tape, the video unit stops	26
	playback, ending program capture.
	Start video capture about 20 seconds after
	the point where the recording begins.
After finishing video	⬤ If you want to erase the file because of
capture, the video file	limited hard disk space, start the program
remains in the JCPT folder	once then close it. The video remaining in	—
(where the program run file	the JCPT folder will be cleared.
is contained).
JLIP initialization not	⬤ Make sure that the IRQ (Interrupt ReQuest)
possible.	is not being used by another device.
	⬤ COM port selection is wrong. Confirm the	18
	COM port number and execute JLIP
	initialization again.
With Video capture/	⬤ In this case, video capture is not possible
Transfer done in Automatic	using the "Frame Picture" setting. Change
Transfer mode, the captured	the setting to "Field Picture" and try video	29
image looks like two	capture again.
pictures laid one upon
another.

The monitor displays of the application software illustrated in this manual may differ from those you are actually viewing depending on the operating environment of your computer.

Operation will be significantly slower when used in an environment other than that recom- mended (page 14).

While basic VCR operations such as playback and fast-forward are available, a "transmis- sion error" may occur in some models during video transfer. In this case, start the software again, and turn the power of the Video Capture Docking Station off and on.