TROUBLESHOOTING 
65
MESSAGE | ⬤ POSSIBLE CAUSE | |
⬛ CORRECTIVE ACTION | ||
| ||
|
| |
Error – – This application will | ⬤ The COM port used for the JLIP connector is not | |
close. | selected, or the COM port is selected but the | |
Check devices – – Confirm | connection is wrong. | |
that power is ON. | ⬛ Check the connected COM port and select it on the | |
| "Serial Port Selection" screen (☞ pg. 46). | |
|
| |
No devices detected to | ⬤ Power is not supplied or the connection is wrong. | |
connect. | ⬛ Connect the devices correctly and turn them on | |
Power ON all devices in | (☞ pg. 42, 43). | |
system. |
| |
|
| |
Communication error | ⬤ Device is not turned on or cable is disconnected. | |
(&H (number)) | ⬛ Connect the device correctly and turn it on | |
Check cable connection. | (☞ pg. 42, 43). | |
| ⬛ If device was turned off and on again during | |
| operation, click "OK". All devices should function | |
| properly. | |
|
| |
Select the device to control. | ⬤ The line where the name of the device to use | |
| appears is not clicked. | |
| ⬛ Click on it and "OK" (☞ pg. 47). | |
|
| |
No video cassette!! | ⬤ The video cassette is not loaded in the camcorder. | |
Load a video cassette to ID | When the video cassette is removed during | |
(number). | operation, this message appears. | |
| ⬛ Insert the video cassette into the camcorder. | |
|
| |
Invalid entry in scene | ⬤ The value of the CUT OUT point is smaller than | |
(number) (There is IN > OUT | the CUT IN point's. | |
condition). Correct the time | ⬛ Set the value of the CUT OUT point so that it is | |
or delete the scene. | larger than the CUT IN point's (☞ pgs. 50, 54). | |
|
| |
Select a number between 0 | ⬤ When correcting the CUT IN/OUT points, the | |
and 29. | value you set differs from the original by over 30 | |
| frames. | |
| ⬛ Select integral number from 0 to 29 (☞ pg. 54). | |
|
| |
Invalid frame number on drop | ⬤ Because the | |
frame counter. | drop frame system, inputting frame 00 and 01 is | |
| impossible. | |
| ⬛ Input frame value other than 00 or 01 | |
| (☞ pgs. 48, 54). | |
|
|
The monitor displays of the application software illustrated in this manual may differ from those you are actually viewing depending on the operating environment of your computer.
