JVC GV-DS1, LYT0002-0M1B, 0397MKV*UN*YP manual Automatically, Select Interval Capture

28VIDEOCAPTURE (cont.)

INTERVAL CAPTURE

The Interval Capture mode is best suited for capturing images at set intervals from a video source unit with a JLIP connector.

Set-up
Capture Mode	Step by Step
Image Format	Automatic
Device Change
Initialize
ID Change
Counter Reset

VCR
I	00:01:23:12F

Capture

Transfer

NOTE:

•Make sure that enough hard disk space is available on your computer before executing video transfer.

For full image data space requirements,

☞ p. 24.

•Transfer of the index image and full image starts at the image box bordered in green.

Click and select the desired image box. •When transferring full image data using the Bitmap image format (9.bmp), the transfer takes a very long time, causing the video source unit to stop playback

automatically.

Preparation

•Make sure all units are properly connected (☞ p. 12).

•Insert a tape into the video source unit.

In the "Set-up" menu, click "Image Format". Select "Field Picture" in the Capture Mode. (☞ p. 29).

1 At the menu bar, click "Set-up" — "Capture Mode" — "Automatic".

•The "Automatic Transfer" window appears.

2 Select the data to be transferred.

•When you select "Index Image", only the index image (80 x 60 pixels) is transferred to your computer.

•When you select "Index & Full Image", both index image (80 x 60 pixels) and full image (640 x 480 pixels) are transferred to the computer.

3 Select "Interval Capture".

4 Set the interval.

•Select the time interval at which images are captured.

5 Set the number of images to be captured and click "OK".

•From 1 up to 99

6 Click "Window" — "VCR" to call up the VCR Operation Window. Start video playback a few seconds prior to the point where you want image capturing to start.

7 Operate the video source unit via the VCR Operation window and click the "Transfer" button at the desired image to start the capture function.

1.The message "No. 1 index image being transferred" appears while the index image is being transferred to the computer.

2.When you select "Index & Full Image" in step 2, the message "No. 1 full image being transferred" appears while the full image is being transferred to the computer.

3.The message "Index No. 2 being scanned" appears while the video tape is fast-for- warded and played at the time intervals set in step 4 to scan the video data on the VCR.

•The image selected when "Transfer" is clicked is captured and subsequent images are captured at the time interval specified by the counter value selected in step 4.

•The video source unit enters the Pause mode when capture is complete.