JVC GV-DS1 manual Advanc ED Operat Ions, Access Pause Time CORREC- Tion Dialog BOX, Enter Value

64

ADVANCEDOPERATIONS (cont.)

Adjusting the gap between the stored edit-start point in the computer and the dubbed one in the recording deck

During dubbing, the beginning of the scene stored in the computer can be missed or the scene prior to the transition you chose for the edit-start point can be dubbed into the recording deck. When these cases occur, adjust the gap for more accurate editing.

1 CHECK EDIT-START TIMING After dubbing (☞ pg. 52), play back the dubbed scene.

2 ACCESS "PAUSE TIME CORREC- TION" DIALOG BOX

Choose "Pause Time" from "File" on the MOVIE PLAYER window.

•The "Pause Time Correction" dialog box appears.

3 ENTER VALUE

To adjust the edit-start timing, enter a new value from 0.00 sec. to 2.60 sec.

When the scene prior to the transition you chose for edit-start point is dubbed:

Enter a smaller value than 1.30.

When the beginning of the scene stored in the computer is missed:

Enter a larger value than 1.30. •Factory preset is 1.30 sec..

4 DETERMINE VALUE

Click "OK".

•This value is stored in the computer.

5 CHECKAGAIN EDIT-START TIMING

To check the corrected edit-start timing, dub the stored scenes and play them back.

NOTE:

Even if the edit-start timing is adjusted, there can be a slight margin between the adjusted edit-start point and the dubbed scenes' one.

MOVIE PLAYER
File	Edit	Video Printer	Help
New		Ctrl+N 00:00:01:20F		ID	06	FILE	travel

Open		Ctrl+O	MEMO
Save		Ctrl+S			Europe Tour
Save As...		Ctrl+A		SCENE START		MODE
ID Change
						STILL
	Device Change				CUT OUT
						PLAY
	Name Change				00:03:27:14F
Pause Time...					00:10:40:18F	SEARCH
	Open VCR Control Window				00:20:33:10F	SLOW
	Close Serial
						FF
	Initialize
						REW
	Counter Reset				00:10:04:28F
	Exit

IN/OUT

Pause Time Correction

Type in the value from 0.00(sec) to 2.60(sec), to adjust pause time during editing.

Pre-start time = 1.30 (sec)

OK CANCEL