Xerox 07W & -11W, 05W manual Reset Terminal, New Connection

Setup Menus

Reset Terminal

This will reset the current terminal emulation mode.

New Connection...

Factory default: Serial, Com 1

This will display a dialog box which enables you to make a serial or network host connection.

The Type option specifies whether a serial or network connection is to be made. Clicking the arrow button will display a drop-down list box containing all the possible settings.

The Services option specifies the port or network host node which TeemTalk is to communicate with. This is a text box with an associated drop-down list box. You can either make a selection from the list box or enter a valid host name or internet address in the text box.

Making A Serial Host Connection

To connect to a serial host, select Serial in the Type list box (default), then select the Com port required in the Services list box. Click the Configure... button to display the Serial Settings dialog box and make sure the settings match that of the host. Click OK then click Connect.

Note: These options are described in the Serial Settings section later in this chapter and only apply when the connection type is set to Serial.

7-9