Setting Wizard
Internet Camera Name | The default camera name is “IC1500Wg”. It is recommended to enter a meaningful | |
name for the camera. | ||
| ||
|
| |
| The wizard will auto setup an available IP Address to the camera. For example: if the | |
IP Address | IP address of the network is 192.168.2.x, the wizard will search an unused IP Address | |
from 192.168.2.250 to 192.168.2.0 and assign the camera an available IP Address. | ||
| You are allowed to enter another IP Address to change the setting. | |
|
| |
| The wizard will auto search the Subnet Mask setting of the network and set the | |
Subnet Mask | camera in the same Subnet Mask. | |
| ||
| You can enter another Subnet Mask to change the setting. | |
|
| |
| The wizard will auto search the Gateway setting of the network and set the camera to | |
Gateway | use the same Gateway. | |
| ||
| You can enter another Gateway to change the setting. | |
|
| |
Video Port | It defines the video stream port. The default value is “4321”. | |
|
| |
Cancel | Click “Cancel” to stop wizard setting. | |
|
| |
Finish | Click “Finish” to complete the camera setting. | |
|
|
When you finish the camera setting, you can click “Ok” to run the “Camera Viewer” immediately or click “Cancel” to run the “Camera Viewer” later.
16