Asus AT5NM10T-I manual Chassis intrusion connector 4-1 pin Chassis

Page 23

4.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

5.Internal speaker connector (4-pin SPEAKER)

The 4-pin connector is for the chassis-mounted system warning speaker. The speaker allows you to hear system beeps and warnings.

ASUS AT5NM10-I

E5179_AT5NM10-I.indb 14

1-14

12/22/09 5:56:02 PM

Image 23

Contents Motherboard E5179 First Edition December Contents AI NET Canadian Department of Communications Statement Federal Communications Commission StatementAbout this guide Safety informationElectrical safety Operation safetyBold text Where to find more informationConventions used in this guide TypographyCPU AT5NM10-I specifications summarySpecifications are subject to change without notice Onboard LED Before you proceedMotherboard layout Layout contentsMotherboard overview Overview Central Processing Unit CPUSystem memory Dimm Memory configurationsDS Brand DDR2-800 MHz capabilityE5179AT5NM10-I.indb 12/22/09 55550 PM SS Single-sided / DS Double-sided Dimm support PCI slot Installing an expansion cardConfiguring an expansion card Expansion slotClear RTC RAM 3-pin Clrtc JumpersUSB device wake-up 3-pin USBPW5-8 Keyboard/mouse power 3-pin PS2USBPW1-4Rear panel connectors ConnectorsATX power connectors 24-pin EATXPWR, 4-pin ATX12V Internal connectorsUSB connector 10-1 pin USB56, USB78 Serial ATA connectors 7-pin SATA1, SATA2Internal speaker connector 4-pin Speaker Chassis intrusion connector 4-1 pin ChassisFront panel audio connector 10-1 pin Aafp CPU and chassis fan connectors 3-pin CPUFAN, 3-pin ChafanReset button 2-pin Reset System panel connector 10-1 pin FpanelSystem power LED 2-pin Pled ATX power button/soft-off button 2-pin PwrbtnDigital audio connector 4-1 pin Spdifout Serial port connectors 10-1 pin COM2To run the Support DVD Installing an operating systemSoftware support Support DVD informationUpdating the Bios Managing and updating your BiosAsus Update utility Installing Asus UpdateAsus EZ Flash Select Update Bios from a file, then click NextRecovering the Bios Asus CrashFree BiosMain menu Bios setup programEntering Bios Setup at startup Entering Bios Setup after PostSata 1/2 System TimeSystem Date Day xx/xx/xxxx System Information Storage ConfigurationAdvanced menu Chipset CPU ConfigurationOnboard Devices Configuration USB Configuration Acpi Apic Support Enabled Power menuSuspend Mode S3 Only Acpi 2.0 Support EnabledHardware Monitor APM ConfigurationBoot Settings Configuration Boot menuBoot Device Priority Select the Change Supervisor Password item and press Enter Wait For ‘F1’ If Error EnabledHit ‘DEL’ Message Display Enabled Change Supervisor PasswordPassword Check Setup User Access Level Full AccessChange User Password Clear User PasswordExpress Gate Auto Tools menuAI NET Check Realtek LAN cable DisabledExit menu