Cisco Systems CTSMX30055K9 manual Conference 1..1 MaxReceiveCallRate

Page 38

Cisco TelePresence MX Series

Administrator guide

Table of contents

Introduction

Web interface

Advanced settings

Appendices

 

38

 

 

Conference [1..1] MaxReceiveCallRate

Specify the maximum receive call rate to be used when placing or receiving calls.

Requires user role: ADMIN

Value space: <64..6000>

Range: Select a value between 64 and 6000 kbps.

Example: Conference 1 MaxReceiveCallRate: 6000

Conference [1..1] VideoBandwidth Mode

Set the conference video bandwidth mode.

Requires user role: ADMIN

Value space: <Dynamic/Static>

Dynamic: The available transmit bandwidth for the video channels are distributed among the currently active channels. If there is no presentation, the main video channels will use the bandwidth of the presentation channel.

Static: The available transmit bandwidth is assigned to each video channel, even if it is not active.

Example: Conference 1 VideoBandwidth Mode: Dynamic

Conference [1..1] PacketLossResilience Mode

Set the packetloss resilience mode. This configuration will only take effect for calls initiated after the configuration is set.

Requires user role: ADMIN

Value space: <On/Off>

On: Enable the packetloss resilience.

Off: Disable the packetloss resilience.

Example: Conference 1 PacketLossResilience Mode: On

Conference [1..1] Presentation Policy

Control how the presentation service is to be performed.

Requires user role: ADMIN

Value space: <LocalRemote/LocalOnly>

LocalRemote: The presentation will be shown locally and sent to remote side.

LocalOnly: The presentation will only be shown locally.

Example: Conference 1 Presentation Policy: LocalRemote

Conference [1..1] VideoBandwidth MainChannel Weight

The available transmit video bandwidth is distributed on the main channel and presentation channel according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth as the presentation channel.

Requires user role: ADMIN

Value space: <1..10>

Range: 1 to 10.

Example: Conference 1 VideoBandwidth MainChannel Weight: 5

Conference [1..1] IncomingMultisiteCall Mode

Set the incoming Multisite call mode. The MultiSite feature allows participants from more than two locations to join a meeting — by video and/or telephone.

Requires user role: ADMIN

Value space: <Allow/Deny>

Allow: Accept incoming calls to an already active call/conference. The incoming call will be added to the MCU conference.

Deny: The system will not accept incoming calls when you are in a call. The calling side will receive a busy signal.

Example: Conference 1 IncomingMultisiteCall Mode: Allow

Conference [1..1] VideoBandwidth PresentationChannel Weight

The available transmit video bandwidth is distributed on the main channel and presentation channel according to "MainChannel Weight" and "PresentationChannel Weight". If the main channel weight is 2 and the presentation channel weight is 1, then the main channel will use twice as much bandwidth as the presentation channel.

Requires user role: ADMIN

Value space: <1..10>

Range: 1 to 10.

Example: Conference 1 VideoBandwidth PresentationChannel Weight: 5

D14850.02 MX Series Administrator Guide (TC5.0) 2011 NOVEMBER © 2011 Cisco Systems, Inc. All rights reserved.

www.cisco.com

Image 38
Contents Cisco TelePresence MX Series MX300 MX200Table of contents Cisco TelePresence MX SeriesIntroduction Intellectual property rights Software User documentationCisco contacts Products covered in this guideSoftware release notes Software download New features and improvementsWhat’s new­in this version Advanced configuration menu changes Other enhancementsFeatures and benefits Cisco TelePresence MX Series at a glanceCisco TelePresence MX Series Web interface Sign Starting the web interfaceConnect to the video system Sign outSet the new password Changing the system/codec passwordClick your user name Open the Change Password dialog box Enter passwordsMain menu Interactive menuMenu availability and user roles Open sub-pagesSystem information Login information System informationLog files XML files Search functionality Advanced configurationChanging system settings Upload a custom wallpaper file Selecting a wallpaperSelect a wallpaper Sign in banner Enter the text message An active sign in bannerCalling someone Sharing contentsPlacing calls Address input fieldControlling and monitoring a call Local layout control Select a layoutMain source Display area Take live snapshots Enabling the live snapshot featureTaking snapshots Upgrading the system software Uploading the SSL certificate Certificate managementUploading the trusted CA certificates list About audit logging Enable secure audit loggingAudit certificate list Upload the audit certificate listSecurity mode User administrationDefault user account About user rolesDeactivating a user account Creating a new user accountEditing user details Deleting a user accountRestarting the system Advanced settings Overview of the advanced settings Find the IP address of your system Open the web interfaceNetworkServices SSH AllowPublicKey Cisco TelePresence MX Series Audio settings Cameras settings Conference settings Conference 1..1 Encryption Mode Conference 1..1 MicUnmuteOnDisconnect ModeConference 1..1 DoNotDisturb Mode Conference 1..1 DefaultCall ProtocolConference 1..1 VideoBandwidth MainChannel Weight Conference 1..1 VideoBandwidth ModeConference 1..1 PacketLossResilience Mode Conference 1..1 IncomingMultisiteCall ModeH323 settings H323 Profile 1..1 Gatekeeper Address H323 Profile 1..1 CallSetup ModeH323 Profile 1..1 Gatekeeper Discovery H323 Profile 1..1 H323Alias E164Network settings Network 1..1 IPv6 Gateway Network 1..1 QoS ModeNetwork 1..1 QoS Diffserv Signalling Network 1..1 IPv6 AssignmentNetwork 1..1 QoS Diffserv Video Network 1..1 IEEE8021X ModeNetwork 1..1 IEEE8021X Password Network 1..1 IEEE8021X TlsVerifyNetwork 1..1 IEEE8021X Eap Md5 Network 1..1 TrafficControl ModeNetwork 1..1 RemoteAccess Allow Network 1..1 IEEE8021X Eap TtlsNetworkServices settings NetworkServices Https Mode NetworkServices Http ModeNetworkServices Https Ocsp Mode NetworkServices Https VerifyServerCertificateNetworkServices Snmp CommunityName NetworkServices NTP AddressNetworkServices SIP Mode NetworkServices Snmp SystemContactPhonebook settings Provisioning settings RTP settings Security settings SerialPort settings SIP settingsSIP Profile 1..1 Outbound SIP Profile 1..1 DefaultTransportSIP Profile 1..1 TlsVerify SIP Profile 1..1 Proxy 1..4 AddressStandby settings SystemUnit settings Time Zone Time settingsTime TimeFormat Time DateFormatUserInterface settings Video settingsVideo Input Source 1..2 OptimalDefinition Profile Video Input Source 1..2 CameraControl ModeVideo Input Source 1..2 CameraControl CameraId Video Input Source 1..2 OptimalDefinition Threshold60fpsVideo Input DVI 1 Type Video DefaultPresentationSourceVideo Input Source 1..2 Quality Video ControlPanel BrightnessVideo Layout LocalLayoutFamily Video OSD ModeVideo OSD LoginRequired Video Layout RemoteLayoutFamilyVideo Output LCD 1 MonitorRole Video Output LCD 1 ResolutionVideo AllowWebSnapshots Video Output LCD 1 BrightnessExperimental CapsetFilter Experimental settingsVideo WallPaper Experimental CapsetReductionExperimental NetworkServices UPnP Timeout Experimental CTMSSupport ModeExperimental NetworkServices UPnP Mode Experimental Conference 1..1 ReceiverBasedDownspeedingExperimental SystemUnit CrashReporting URI Experimental SystemUnit CrashReporting ModeExample Experimental SystemUnit CrashReporting Mode Off Example Experimental SystemUnit CrashReporting URIAppendices Setting a root password Setting the system passwordSetting the Administrator settings menu password Downloading the provisioning configuration template Cisco VCS provisioningOptimal definition profiles Optimal definition for systems supporting 1080pClearPath Packet loss resilience Technical specification for MX300/MX200 DVI-ISIP Web interface Advanced settings User documentation on the Cisco web site Document categories
Related manuals
Manual 2 pages 49.92 Kb

CTSMX30055K9 specifications

Cisco Systems has long been recognized as a leader in networking and communication technologies, and the Cisco TelePresence MX300 (CTSMX30055K9) exemplifies the company’s commitment to fostering exceptional video collaboration solutions. The MX300 is particularly designed for medium-sized meeting rooms, making it an ideal choice for enterprises looking to enhance their videoconferencing capabilities.

One of the standout features of the Cisco MX300 is its remarkable video experience. With support for up to 1080p high-definition video at 30 frames per second, users can enjoy crisp and clear visual quality during meetings. This resolution ensures that participants feel as though they are in the same room, regardless of their physical location. The MX300 also includes advanced video processing technology, which helps optimize picture quality even in varying bandwidth conditions.

In terms of audio, the MX300 is equipped with Cisco's intelligent audio technology. It utilizes multiple microphones and smart processing to ensure that all voices in the room are captured clearly, eliminating unwanted background noise. This results in a natural conversational experience, allowing for seamless interactions among participants.

Another significant characteristic of the MX300 is its user-friendly interface. The device comes with a simple remote control and touchscreen capabilities that make it easy for users to initiate calls, share content, and manage meetings. Integration with Cisco's Webex platform further enhances its usability, allowing users to join meetings with just one click.

The MX300 is known for its flexibility and scalability. It can be easily integrated into an existing IT infrastructure, supporting various endpoints and devices, which contributes to a more cohesive video collaboration experience. Additionally, it features interoperability with other video conferencing systems, ensuring that organizations can connect with partners and clients regardless of their technology stack.

Security is another strong suit of the Cisco MX300. The device incorporates robust security protocols, including encryption and secure access controls, safeguarding sensitive information shared during meetings. This emphasis on security is critical for organizations seeking to maintain compliance and protect their data.

Overall, the Cisco TelePresence MX300 (CTSMX30055K9) is a powerful solution for medium-sized meeting rooms, offering high-definition video, intelligent audio processing, and a user-friendly interface. With its flexibility, scalability, and strong security features, the MX300 stands out as an ideal choice for organizations committed to effective communication and collaboration. By enhancing the quality of virtual meetings, Cisco's MX300 continues to play a vital role in transforming the workplace into an environment where ideas can be shared effortlessly, fostering innovation and productivity.