Cisco Systems CTSMX30055K9 manual Network 1..1 IEEE8021X Eap Md5, Network 1..1 IEEE8021X Eap Ttls

Page 44

Cisco TelePresence MX Series

Administrator guide

Table of contents

Introduction

Web interface

Advanced settings

Appendices

 

44

 

 

Network [1..1] IEEE8021X Eap Md5

Set the Md5 (Message-Digest Algorithm 5) mode. This is a Challenge Handshake Authentication Protocol that relies on a shared secret. Md5 is a Weak security.

Requires user role: ADMIN

Value space: <On/Off>

On: The EAP-MD5 protocol is enabled (default).

Off: The EAP-MD5 protocol is disabled.

Example: Network 1 IEEE8021X Eap Md5: On

Network [1..1] IEEE8021X Eap Ttls

Set the TTLS (Tunneled Transport Layer Security) mode. Authenticates LAN clients without the need for client certificates. Developed by Funk Software and Certicom. Usually supported by Agere Systems, Proxim and Avaya.

Requires user role: ADMIN

Value space: <On/Off>

On: The EAP-TTLS protocol is enabled (default).

Off: The EAP-TTLS protocol is disabled.

Example: Network 1 IEEE8021X Eap Ttls: On

Network [1..1] MTU

Set the Ethernet MTU (Maximum Transmission Unit).

Requires user role: ADMIN

Value space: <576..1500>

Range: Select a value from 576 to 1500 bytes.

Example: Network 1 MTU: 1500

Network [1..1] Speed

Set the Ethernet link speed.

Requires user role: ADMIN

Value space: <Auto/10half/10full/100half/100full/1000full> Auto: Autonegotiate link speed.

10half: Force link to 10 Mbps half-duplex.

10full: Force link to 10 Mbps full-duplex.

100half: Force link to 100 Mbps half-duplex.

100full: Force link to 100 Mbps full-duplex.

1000full: Force link to 1 Gbps full-duplex.

Example: Network 1 Speed: Auto

Network [1..1] IEEE8021X Eap Tls

Enable or disable the use of EAP-TLS (Transport Layer Security) for IEEE802.1x connections. The EAP-TLS protocol, defined in RFC5216, is considered one of the most secure EAP standards. LAN clients are authenticated using client certificates.

Requires user role: ADMIN

Value space: <Off/On>

Off: The EAP-TLS protocol is disabled.

On: The EAP-TLS protocol is enabled (default).

Example: Network 1 IEEE8021X Eap Tls: On

Network [1..1] TrafficControl Mode

Set the network traffic control mode to decide how to control the video packets transmission speed.

Requires user role: ADMIN

Value space: <On/Off>

On: Transmit video packets at maximum 20 Mbps. Can be used to smooth out bursts in the outgoing network traffic.

Off: Transmit video packets at link speed.

Example: Network 1 TrafficControl: On

Network [1..1] IEEE8021X Eap Peap

Set the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN clients without the need for client certificates. Developed by Microsoft, Cisco and RSA Security.

Requires user role: ADMIN

Value space: <On/Off>

On: The EAP-PEAP protocol is enabled (default).

Off: The EAP-PEAP protocol is disabled.

Example: Network 1 IEEE8021X Eap Peap: On

Network [1..1] RemoteAccess Allow

Filter IP addresses for access to ssh/telnet/HTTP/HTTPS.

Requires user role: ADMIN

Value space: <S: 0, 255>

Format: String with a maximum of 255 characters, comma separated IP adresses or IP range. Example: Network 1 RemoteAccess Allow: "192.168.1.231, 192.168.1.182"

D14850.02 MX Series Administrator Guide (TC5.0) 2011 NOVEMBER © 2011 Cisco Systems, Inc. All rights reserved.

www.cisco.com

Image 44
Contents Cisco TelePresence MX Series MX300 MX200Table of contents Cisco TelePresence MX SeriesIntroduction Intellectual property rights User documentation Cisco contactsSoftware Products covered in this guideSoftware release notes Software download New features and improvementsWhat’s new­in this version Advanced configuration menu changes Other enhancementsFeatures and benefits Cisco TelePresence MX Series at a glanceCisco TelePresence MX Series Web interface Starting the web interface Connect to the video systemSign Sign outChanging the system/codec password Click your user name Open the Change Password dialog boxSet the new password Enter passwordsInteractive menu Menu availability and user rolesMain menu Open sub-pagesSystem information Login information System informationLog files XML files Search functionality Advanced configurationChanging system settings Upload a custom wallpaper file Selecting a wallpaperSelect a wallpaper Sign in banner Enter the text message An active sign in bannerSharing contents Placing callsCalling someone Address input fieldControlling and monitoring a call Local layout control Select a layoutMain source Display area Take live snapshots Enabling the live snapshot featureTaking snapshots Upgrading the system software Uploading the SSL certificate Certificate managementUploading the trusted CA certificates list Enable secure audit logging Audit certificate listAbout audit logging Upload the audit certificate listUser administration Default user accountSecurity mode About user rolesCreating a new user account Editing user detailsDeactivating a user account Deleting a user accountRestarting the system Advanced settings Overview of the advanced settings Find the IP address of your system Open the web interfaceNetworkServices SSH AllowPublicKey Cisco TelePresence MX Series Audio settings Cameras settings Conference settings Conference 1..1 MicUnmuteOnDisconnect Mode Conference 1..1 DoNotDisturb ModeConference 1..1 Encryption Mode Conference 1..1 DefaultCall ProtocolConference 1..1 VideoBandwidth Mode Conference 1..1 PacketLossResilience ModeConference 1..1 VideoBandwidth MainChannel Weight Conference 1..1 IncomingMultisiteCall ModeH323 settings H323 Profile 1..1 CallSetup Mode H323 Profile 1..1 Gatekeeper DiscoveryH323 Profile 1..1 Gatekeeper Address H323 Profile 1..1 H323Alias E164Network settings Network 1..1 QoS Mode Network 1..1 QoS Diffserv SignallingNetwork 1..1 IPv6 Gateway Network 1..1 IPv6 AssignmentNetwork 1..1 IEEE8021X Mode Network 1..1 IEEE8021X PasswordNetwork 1..1 QoS Diffserv Video Network 1..1 IEEE8021X TlsVerifyNetwork 1..1 TrafficControl Mode Network 1..1 RemoteAccess AllowNetwork 1..1 IEEE8021X Eap Md5 Network 1..1 IEEE8021X Eap TtlsNetworkServices settings NetworkServices Http Mode NetworkServices Https Ocsp ModeNetworkServices Https Mode NetworkServices Https VerifyServerCertificateNetworkServices NTP Address NetworkServices SIP ModeNetworkServices Snmp CommunityName NetworkServices Snmp SystemContactPhonebook settings Provisioning settings RTP settings Security settings SerialPort settings SIP settingsSIP Profile 1..1 DefaultTransport SIP Profile 1..1 TlsVerifySIP Profile 1..1 Outbound SIP Profile 1..1 Proxy 1..4 AddressStandby settings SystemUnit settings Time settings Time TimeFormatTime Zone Time DateFormatUserInterface settings Video settingsVideo Input Source 1..2 CameraControl Mode Video Input Source 1..2 CameraControl CameraIdVideo Input Source 1..2 OptimalDefinition Profile Video Input Source 1..2 OptimalDefinition Threshold60fpsVideo DefaultPresentationSource Video Input Source 1..2 QualityVideo Input DVI 1 Type Video ControlPanel BrightnessVideo OSD Mode Video OSD LoginRequiredVideo Layout LocalLayoutFamily Video Layout RemoteLayoutFamilyVideo Output LCD 1 Resolution Video AllowWebSnapshotsVideo Output LCD 1 MonitorRole Video Output LCD 1 BrightnessExperimental settings Video WallPaperExperimental CapsetFilter Experimental CapsetReductionExperimental CTMSSupport Mode Experimental NetworkServices UPnP ModeExperimental NetworkServices UPnP Timeout Experimental Conference 1..1 ReceiverBasedDownspeedingExperimental SystemUnit CrashReporting Mode Example Experimental SystemUnit CrashReporting Mode OffExperimental SystemUnit CrashReporting URI Example Experimental SystemUnit CrashReporting URIAppendices Setting a root password Setting the system passwordSetting the Administrator settings menu password Downloading the provisioning configuration template Cisco VCS provisioningOptimal definition profiles Optimal definition for systems supporting 1080pClearPath Packet loss resilience Technical specification for MX300/MX200 DVI-ISIP Web interface Advanced settings User documentation on the Cisco web site Document categories
Related manuals
Manual 2 pages 49.92 Kb

CTSMX30055K9 specifications

Cisco Systems has long been recognized as a leader in networking and communication technologies, and the Cisco TelePresence MX300 (CTSMX30055K9) exemplifies the company’s commitment to fostering exceptional video collaboration solutions. The MX300 is particularly designed for medium-sized meeting rooms, making it an ideal choice for enterprises looking to enhance their videoconferencing capabilities.

One of the standout features of the Cisco MX300 is its remarkable video experience. With support for up to 1080p high-definition video at 30 frames per second, users can enjoy crisp and clear visual quality during meetings. This resolution ensures that participants feel as though they are in the same room, regardless of their physical location. The MX300 also includes advanced video processing technology, which helps optimize picture quality even in varying bandwidth conditions.

In terms of audio, the MX300 is equipped with Cisco's intelligent audio technology. It utilizes multiple microphones and smart processing to ensure that all voices in the room are captured clearly, eliminating unwanted background noise. This results in a natural conversational experience, allowing for seamless interactions among participants.

Another significant characteristic of the MX300 is its user-friendly interface. The device comes with a simple remote control and touchscreen capabilities that make it easy for users to initiate calls, share content, and manage meetings. Integration with Cisco's Webex platform further enhances its usability, allowing users to join meetings with just one click.

The MX300 is known for its flexibility and scalability. It can be easily integrated into an existing IT infrastructure, supporting various endpoints and devices, which contributes to a more cohesive video collaboration experience. Additionally, it features interoperability with other video conferencing systems, ensuring that organizations can connect with partners and clients regardless of their technology stack.

Security is another strong suit of the Cisco MX300. The device incorporates robust security protocols, including encryption and secure access controls, safeguarding sensitive information shared during meetings. This emphasis on security is critical for organizations seeking to maintain compliance and protect their data.

Overall, the Cisco TelePresence MX300 (CTSMX30055K9) is a powerful solution for medium-sized meeting rooms, offering high-definition video, intelligent audio processing, and a user-friendly interface. With its flexibility, scalability, and strong security features, the MX300 stands out as an ideal choice for organizations committed to effective communication and collaboration. By enhancing the quality of virtual meetings, Cisco's MX300 continues to play a vital role in transforming the workplace into an environment where ideas can be shared effortlessly, fostering innovation and productivity.